40 Series axle widening

[Narrowscopeofreality]

I realise there's been a few threads about this subject, and i've read them all, but my question is a bit more specific.

The widening method on the front axle using IFS hubs WITH hub spacer.

In a stock setup the rotor is pretty much shielded by the wheel, has anyone had any issues with how far the wheel is now spaced out from the rotor? eg rock damage ect.

Cheers

[Z()LTAN]

Ive run 3" spacers and offset rims for some time now, the brake disk is about 3" outside the wheel.

Ive hit it on occasions but has caused no issues. You would have to be real unlucky to smash a rotor that bad.

[Narrowscopeofreality]

That's good to hear. You probably drive harder then I ever will so I should be sweet.

Thanks mate.

[Dannyboy]

with -35 offset or whatever the normal sunnys are the rotor is still well protected, would be unlucky to hit anything there.

[loosecanon]

Don't mean to hi-jack

Danny do you have a build thread? I would like to see how you made your front bar.

that is all

[Dannyboy]

Don't mean to hi-jack

Danny do you have a build thread? I would like to see how you made your front bar.

that is all

Yeah mate,
http://www.outerlimits4x4.com/viewtopic ... 6&t=213677

There isn't any detail on how i did the bar i will put some up there tonight when i get hoe from work.

[Narrowscopeofreality]

Cheers Dannyboy

[shorty_f0rty]

i've got 6" wide skinny tyres on and haven't had any issues with the rotors being exposed...