Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

1fz-fe running rough

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 367
Joined: Sun Oct 04, 2009 5:50 pm
Location: Penrith, Sydney

1fz-fe running rough

Post by howsie »

Recently my dual fuel 1fz-fe has started to run rough. Have noticed that there seems to be a ticking noise from exhaust. Can barely be heard when under the bonnet but is quite loud standing at the drivers door. Have also noticed what sounds like noisy lifters.any ideas.

Car is regularly run on petrol and up until now has run like a dream.
93 RV, 5 in tough dog lift, dobinsons shocks and coils, PA, dual fuel, many many oil leaks and a ton of character.
Posts: 1042
Joined: Mon May 05, 2008 6:33 pm
Location: MACKAY

Re: 1fz-fe running rough

Post by SIMMO84 »

Does it have gas fitted, if so I'd be betting its burnt out a valve seat. Common problem.
Wtb, 105 series rear tyre carrier, alloys and tyres.
Posts: 367
Joined: Sun Oct 04, 2009 5:50 pm
Location: Penrith, Sydney

Re: 1fz-fe running rough

Post by howsie »

SIMMO84 wrote:Does it have gas fitted, if so I'd be betting its burnt out a valve seat. Common problem.
As stated is dual fuel ie gas and petrol. Gas system was installed in 97 but has always run perfectly, has never idled rough always starts within a second.of turning the key.

Was thinking something to do with valves but the fact that there is a ticking as well has convinced me to look elsewhere.

As well as the fact that valves usually show signs of wear long before they burn out. Although I must admit I an no expert in this regard but this is.net understanding.
93 RV, 5 in tough dog lift, dobinsons shocks and coils, PA, dual fuel, many many oil leaks and a ton of character.
Posts: 1105
Joined: Wed Jan 23, 2008 8:56 pm
Location: central coast down under

Re: 1fz-fe running rough

Post by stilivn »

does it increase in frequency with speed or revs?
1993 80 series, 4" tough dog adjustable bb lift kit, LPG, 35" MTR'S
brooksy wrote:Branden Tagg.....He is the King of all f@rkups & a Gimps bitch after hours
Posts: 1105
Joined: Wed Jan 23, 2008 8:56 pm
Location: central coast down under

Re: 1fz-fe running rough

Post by stilivn »

when was the last time you changed your plugs and leads and where did you get them from
1993 80 series, 4" tough dog adjustable bb lift kit, LPG, 35" MTR'S
brooksy wrote:Branden Tagg.....He is the King of all f@rkups & a Gimps bitch after hours
Posts: 367
Joined: Sun Oct 04, 2009 5:50 pm
Location: Penrith, Sydney

Re: 1fz-fe running rough

Post by howsie »

stilivn wrote:does it increase in frequency with speed or revs?
Lifter type noise gets faster but not louder the loud ticking disappears with revs as does the roughness. I will be checking exhaust manifold soon as my brothers car made a similar noise because of a loose manifold.

Plugs were thoroughly checked about a week ago as were the leads all were as close to perfect as you'll get.
93 RV, 5 in tough dog lift, dobinsons shocks and coils, PA, dual fuel, many many oil leaks and a ton of character.
Posts: 613
Joined: Tue Sep 06, 2005 3:17 pm
Location: Newcastle/Bathurst, NSW

Re: 1fz-fe running rough

Post by UhhOhh »

Aren't these an over head cam? Check your valve clearances/adjust your valve clearances.
What do we want? TIME TRAVEL! When do we want it? THAT'S IRRELEVANT!
Posts: 27
Joined: Wed Jul 27, 2011 2:55 pm

Re: 1fz-fe running rough

Post by crazy eyez »

do a compression test more than likely it will be a valve burnt out .. or a colapsed valve seat.. very common problem with the 1fz motor . it is even more common when they are on gas .... gas is for BBQS not cars hahahaha
cheers
Posts: 30
Joined: Fri Feb 10, 2012 8:07 pm
Location: Bundy, QLD

Re: 1fz-fe running rough

Post by Glenn-80 »

UhhOhh wrote:Aren't these an over head cam? Check your valve clearances/adjust your valve clearances.
Double over head cam with shimmed buckets ;)
I fix Patrols all day. Then I get in my Cruiser and drive home.
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests