Hello all,
I have a maverick which originally had a limited slip rear diff which was replaced with an air locker. I am now taking out the diff center including the air locker to sell. I have replaced the diff center with an open diff center that I had lying around and am now struggling to get the half axles (from the limited slip diff) to insert on their splines. The spline count looks the same but I suspect the half shafts for a open diff axle must be a smaller diameter to those of a limited slip diff.
Can anyone here confirm or deny this before I pull the center back out to check. It was a real bitch to lift and install into the diff housing so I don't want to take it out to check if I can avoid it.
Thanx
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
GQ/MAV REAR AXLE OPTIONS
GQ/MAV REAR AXLE OPTIONS
SWB MAVERICK
Re: GQ/MAV REAR AXLE OPTIONS
Mate spline count should be 33 there is no difference as far as i know but open centre rear is rare only in early models i beleive.
Re: GQ/MAV REAR AXLE OPTIONS
Is it an MQ low pinion centre?
They are 31 not 33 spline and neck down just at the spline.
They are 31 not 33 spline and neck down just at the spline.
Buds Customs : Street, Track & Trail - Parts & Fabrication - Nissan, Toyota, Custom D60 gear
http://www.facebook.com/budscustoms
http://www.facebook.com/budscustoms
Who is online
Users browsing this forum: No registered users and 8 guests