Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Front Drive shaft for LT230

Tech Talk for Rover owners.

Moderator: Micka

Post Reply
Posts: 10984
Joined: Thu May 29, 2003 3:47 pm
Location: Bum drilling with my buddy Ray!

Front Drive shaft for LT230

Post by GRIMACE »

People have mentioned that the front drive shaft on the LT230 setup is shorter than the front driveshaft on the viscous hub setup.


How much shorter is this ? ? ?



Anthony
Posts: 2384
Joined: Mon Mar 31, 2003 10:05 am
Location: Brisbane or 169.254.243.241

Post by RaginRover »

Don't know but you can grab a front shaft off a 2 door rangie and they fit just fine.

Tom
Posts: 640
Joined: Sat Dec 07, 2002 4:04 pm
Location: Snake Valley VIC

Post by Aquarangie »

AS a rough estimate, about 40mm.

Better off if you decide to do the Lt230 conversion is to get a second hand one and replace the uni's if they are stuffed.

Trav
Land Rover- The Collingwood of 4WD's!!!!
Posts: 10984
Joined: Thu May 29, 2003 3:47 pm
Location: Bum drilling with my buddy Ray!

Post by GRIMACE »

I am doin the lt230 conversion and I have all the bits and peices onthe way (complete 88 rangie).
I am just after the info as I am getting a double cardon fitted to a front shaft I have here and I wanted to make sure it would fit and how much to take off it.

cheers
Anthony
Posts: 41
Joined: Fri Oct 10, 2003 10:45 am
Location: Melbourne

Post by disco200tdi »

I'd wait and measure it on your donor vehicle. I replaced my front shaft with one from a swap meet. It was too long so i just loped a bit off with the drop saw and rewelded it. 10 minutes work max.
John D

Defender 110 2.4
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests