Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Guys,
Just about to do a 2 inch body lift on the shorty and would like to hear any do's and don't in regard to doing this. Have heard that some smaller diameter type blocks tend to flex too much and tear off mounts on body and chassis. Is this correct?
80 series, Locked both ends, Q78ed & a massive 57 k/w to boot!!!!
When we redid my bodymount rubbers the other day, it took us fuck all to do the lot - couple a hours if that. And that was spraying the bolts there and then. Rattle gun at DAMIGES place helps though
Use NEW high tensile bolts, and its worth your while to do bodymount rubbers too...
I just cut a neat 40x40 hole knocked the tabs that hold the nut in place and then just replaced with a new high tensile bolt made a s/s cover plate for the hole sealed it with sticky back rubber and screwed the s/s cover plate on sweet as
