just a few simple questions, who has done it, what problems did u come across, and are you happy with it.
its goin into a 95 model hilux
cheers
steve
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
VN 5L and T700 into hilux
Moderators: toaddog, Elmo, DUDELUX
VN 5L and T700 into hilux
KILLA KUSTOM KABLES
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS
LS1 STANDALONE HARNESS $475ex
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS
LS1 STANDALONE HARNESS $475ex
Re: VN 5L and T700 into hilux
killalux wrote:just a few simple questions, who has done it, what problems did u come across, and are you happy with it.
its goin into a 95 model hilux
cheers
steve
I have a VP 5.0lt with a w56 gearbox, with 4.88's and 37's. Previously I have a t350 behind it with 35's and with no overdrie it sucked. I prefer the maunal becuase of the engine braking pereformance. The 5.0lt goes very well. Seem to be breaking alot with the 37's and dual t/cases Just did the tail shaft and bent my rear springs. Axle wrap and lots of torque
It is a tight fit. I have both a engine fan and A/C. Custom radiator, custom brackets and alot of stuffing around.
It I was to do it again I would do a v6 or smaller V8 enough power and alot more room. I would look at a Vortec chevy v6 similar power to the 5.0lt. You might event look at the toyota V8
Chris.
killalux wrote:yeah thanks, i am tossing up between the holden and toyota v8's, how do you find the gearbox holds up to the power of the 8
I have no problems so far BUT I do not do burnouts on high traction surfaces.
If cost is a problem then do not do a conversion. It will cost you more then you think.
Thinking about it again, it you want to keep the manual look at a Toyota six (7m, etc). This would be the cheapest conversion.
Chris.
cost isnt a main concern within reason of cause, i generaaly dont do burnouts on road etc, but i can be a bit hard on it on gravel, dirt and mud etc.
KILLA KUSTOM KABLES
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS
LS1 STANDALONE HARNESS $475ex
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS
LS1 STANDALONE HARNESS $475ex
I put VP 5litre and t700 in mine as has been said before cooling is the hardest part due to lack of room ,,use an early vh k commadore water pump as it is an inch shorter, handbrake has to be modified were it comes out the firewall as i will hit motor u will find it hard to fit a decent engine fan without putten the fan thru radiator , i overcame this by rear mounting , u will have 2 modify left hand factory haeder ( i didny use the cast 1s not sure if they fit) as u run in2 trouble with clearence on the chassis rail, Std engine mounts that marks say to use arnt strong enufff i think , a few small probs but not that hard im haven trouble with tailshaft bindin on t700 pan at full compression 2, but im runnen gq difff ,,i think it can still be a prob with hilux diffs . only drove it up and down the road out the front befor the coil conversion and it seemed to go hard .... eitha motor ya go with im sure you will be stoked from goen from GUTLUX TO GRUNTLUX .. i have to say the injected 5l has a heaps betta exhaust note tho .....
MYV84B wrote:I put VP 5litre and t700 in mine as has been said before cooling is the hardest part due to lack of room ,,use an early vh k commadore water pump as it is an inch shorter, handbrake has to be modified were it comes out the firewall as i will hit motor u will find it hard to fit a decent engine fan without putten the fan thru radiator , i overcame this by rear mounting , u will have 2 modify left hand factory haeder ( i didny use the cast 1s not sure if they fit) as u run in2 trouble with clearence on the chassis rail, Std engine mounts that marks say to use arnt strong enufff i think , a few small probs but not that hard im haven trouble with tailshaft bindin on t700 pan at full compression 2, but im runnen gq difff ,,i think it can still be a prob with hilux diffs . only drove it up and down the road out the front befor the coil conversion and it seemed to go hard .... eitha motor ya go with im sure you will be stoked from goen from GUTLUX TO GRUNTLUX .. i have to say the injected 5l has a heaps betta exhaust note tho .....
I changed the sump on mine when I went x-over. Used a rear drop sump instead of the standard front drop sump.
The early vh k commadore water pump does this mean that all the pullies and now misaligned?? I swaped the lower 3 pully for a 2 pully one. I only run 2 belts for P/S, A/C and Alt.
Chris.
Chris.
Who is online
Users browsing this forum: No registered users and 0 guests