Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

HELP ME I'm Vibrating!!!!

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 1055
Joined: Sun Nov 16, 2003 3:46 pm
Location: Inala Ponds

HELP ME I'm Vibrating!!!!

Post by basketcase »

I need some help. My 4runner is vibrating really bad. The faster I go the worse it gets, but it only vibrates when I have my foot on the gas.

I have checked all the engine mounts, transfer case mount on the cross member and the uni's seem to be fine.

I did slam the cross member down on a rock a couple weeks ago, but I only noticed this vibrating a week ago and it has been getting worse over the past week.

Help me please!!! :cry:
Posts: 16
Joined: Sun Jun 13, 2004 7:18 pm
Location: Heyfield

Post by bigjedd »

Doeas the vibration appear to show through the steering wheel or is it more seat of the pants.

If its through the steering check for front end or wheel problems if its seat of pants check for drivline problems.
Posts: 1187
Joined: Sat Nov 01, 2003 5:05 pm
Location: melbourne, Knoxfield

Post by matthewK »

which crossmember?

if ya hit it hard enough could move the gear box a few mm
putting the drive shaft off center could that be it?
1995 land rover disco on 265 muddies
Posts: 80
Joined: Thu Mar 13, 2003 8:53 pm
Location: Sydney

help me im vibrating

Post by LowRanger »

My choice would be that you have either a seized or stuffed universal joint.don't just get under and feel the joints for play.Take the shafts out and check to see if the unis move freely as well as haveing no freeplay.
"What !!!!! Not another bloody Landrover"
Posts: 3099
Joined: Wed Dec 11, 2002 10:55 am
Location: Central Queensland

Post by BundyRumandCoke »

Dont sit on the washing machine when the spin cycle is on.









And check those unis, my guess is its one of them, or maybe even a bent tailshaft.
Mud makes excellent toothpaste.
Posts: 1055
Joined: Sun Nov 16, 2003 3:46 pm
Location: Inala Ponds

Post by basketcase »

matthewK wrote:which crossmember?

if ya hit it hard enough could move the gear box a few mm
putting the drive shaft off center could that be it?


I am going with that. But I don't want to go get a new x member because I have to get a new one when I put in my dual cases in a couple of weeks.
Posts: 1055
Joined: Sun Nov 16, 2003 3:46 pm
Location: Inala Ponds

Post by basketcase »

bigjedd wrote:Doeas the vibration appear to show through the steering wheel or is it more seat of the pants.

If its through the steering check for front end or wheel problems if its seat of pants check for drivline problems.


It is coming from underneath for sure.
Posts: 2910
Joined: Thu Jan 02, 2003 4:32 pm
Location: Brisbane

Post by -Mick- »

Check your exhaust :) Recently one of the rubber mounts for my exhaust gave way and now part of the system fouls the underbody

It vibrates like a mofo but only when my foot is on the gas ;)
Posts: 1663
Joined: Mon Nov 04, 2002 6:38 pm
Location: bethania QLD

Re: help me im vibrating

Post by oozuk »

LowRanger wrote:My choice would be that you have either a seized or stuffed universal joint.don't just get under and feel the joints for play.Take the shafts out and check to see if the unis move freely as well as haveing no freeplay.


I'll second this because i've had it happen before, the uni joint wont seem worn untill you remove the rear tailshaft from the car and then check the uni's for play or if there seized, why your there check your g-box and pinion flanges for play as well ..

does you tailshaft have a centre bearing ??(1 piece or 2 piece ?)
if so then that could be flogged out too.....good luck
Trying to finish the Zook

OOZUK buildup
http://www.outerlimits4x4.com/viewtopic.php?t=80949
***KING OF BLING***
Posts: 6693
Joined: Mon Feb 09, 2004 10:13 pm
Location: Newcastle

Post by high n mighty »

Could it be a pinion bearing???Mine was very cranky when I got off the pedal though.
[quote="fool_injected"]
I pity my brother when she is a teenager[/quote]
User avatar
Guy
Posts: 10366
Joined: Thu Dec 12, 2002 8:43 am
Location: Wangaratta

Re: help me im vibrating

Post by Guy »

oozuk wrote:
LowRanger wrote:My choice would be that you have either a seized or stuffed universal joint.don't just get under and feel the joints for play.Take the shafts out and check to see if the unis move freely as well as haveing no freeplay.


I'll second this because i've had it happen before, the uni joint wont seem worn untill you remove the rear tailshaft from the car and then check the uni's for play or if there seized, why your there check your g-box and pinion flanges for play as well ..

does you tailshaft have a centre bearing ??(1 piece or 2 piece ?)
if so then that could be flogged out too.....good luck


I have found that a quick "finger test" will sort this out ... as the truck is still being driven .. after a short run feel the uni joint .. if it is warm or hot .. bingo thats ya stuffed one ..
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 0 guests