Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Side Step Mounting
Side Step Mounting
I am making a set of side steps, out of 3" steel pipe, for a LWB GQ, with a 3" suspension lift and no body lift, and was looking at different designs for mounting them to the chassis, either bolt on or weld on. What I want to know is how have other people done theirs. Photos, descriptions or sketches anything would be appreciated. Thanks.
2008 JK Jeep Wrangler.
buy pipe flanges - 1 per mount. get 10-12mm thick steel about 125 wide and the height of your chassis. mark the steel to suit the pipe flanges. drill and tap out at 10mm or so. weld the plates to the chassis top and bottom ONLY - NOT vertically your chassis may stress crack in due course on cape trips etc. bolt flanges using short bolts, and build tubes from there. too easy
cheers bru
cheers bru
ADHD Racing would like to thank
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Who is online
Users browsing this forum: No registered users and 0 guests