Standard Upper and Lower axle LINK mount point separation

[A1]

As Topic sugests im chassin the standard measurement of separation between the upper and lower link mountin points on a GQ (REAR obviuosly).....


So between centres


Im still havin issues with axle wrap since goin 4 link and i now have 225mm separation which would have to be damn close to standard separation but im curious to actually see wat figure it is ......as u can tell i didnt write this down nor even check wen i begun the mods


cheers

Dan

[Wendle]

ring me this arvo when i am home and i'll crawl under the lowrider and measure it for you..

[big red]

taken from http://forum.patrol4x4.com/viewtopic.php?p=215#215

GU: rear diff suspension arm mounting points.
lower: 58 below centre line of axle housing. [350 above ground]
upper: 178 above centre line of axle housing. [586 above ground]
seperation: 236 vertical

GU: rear chassis suspension arm mounting points.
lower to ground: 540
upper to ground: 673
seperation: 133 vertical

all measurements taken centre to centre.

[A1]

Fuk yeah your a champion BIGRED those measurements would have to be very close to the same on a GQ axle ...........identical u would xpect .................


so separation wise there is very little difference 11mm ...........but maybe its the posi of my lower link centre on the axle as its prob bout 5-10 mm off centre maybe its allowin a slight bit of rotation .....as you can feel the shock load wen you stab the throttle on then off say when coastin at 60 kays ( and its a only a NA diesel so it aint no POWER house )


I only have bout 85mm or so at the chassis end but this shouldnt be a casue of drama if i still have a resonable amount of separation on the axle end ??


cheers BIG RED