bent the gear shifter if nessecary in the vice
with the transfer i dont think ou will need to bend it.
with my 3 inch body i can shift into 4 low but it wants to pop out due to the rubber boot
so all i do is remove the 4 screws when using 4 low
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
HOW HARD IS IT TO INSTALL A BODY LIFT?
have unbolted the body and jacked it up off the chasis. have noticed there are some other mounts that touch the body but are not bolted. there is rubber pad between them. do i need to put spacers in these positions?
1999 SQ625 Manual Grand Vitara. Lifted, Twin Locked, 31' Extremes, dual Batteries, Winch.
Lots of custom gear as I cant afford the proper stuff.
Lots of custom gear as I cant afford the proper stuff.
built4thrashing wrote:have unbolted the body and jacked it up off the chasis. have noticed there are some other mounts that touch the body but are not bolted. there is rubber pad between them. do i need to put spacers in these positions?
for these spots, i used RHS and glued it it with rubber on each side.
Who is online
Users browsing this forum: No registered users and 7 guests