Beadlocked rims drawings or info

Post by **Surfection** » Thu Mar 13, 2003 7:09 pm

Show us some pics duncan !!!

Post by **POS** » Thu Mar 13, 2003 7:18 pm

Surfection wrote:Show us some pics duncan !!!

What aren't my drawings good enough for you! :lol:

Post by **Surfection** » Thu Mar 13, 2003 8:40 pm

bahaha, adrian your pic is going up on the wall at work !!!!!! :lol:

Nah i'm just interested in putting a pic to the description !!

Post by **POS** » Thu Mar 13, 2003 8:56 pm

Surfection wrote:bahaha, adrian your pic is going up on the wall at work !!!!!!

MY PIC

I HOPE ITS NOT GOING UP ON THE TOILET WALL!!!!! :lol:

Post by **Surfection** » Thu Mar 13, 2003 9:33 pm

ROFL

Nah, i couldn't do that to BJ, he would feel so unloved !!

Post by **toymad** » Thu Mar 13, 2003 11:04 pm

Found this pic on pirate, looks easy enough. :shock:

Post by **duncan** » Fri Mar 14, 2003 12:32 am

That picture is exacly what I have done both plates were made out of 6mm plate I firstly marked them out then used a oxy to cut out the 2 rings tack welded them together in 4 places then drilled the holes the correct size for a 10mm tap I taped 4 holes so I could bolt them together and put them on a lathe to machine the inner and outer diameters then finished of the rest of the threaded holes the outside diameter is exactly the same size as a 15 inch rim sat it on top and tacked it in 4 places them stich welded it on so as to minimunize worpage to easy and it cost nothing will post some photos when a mate can get over here with his digital camera

Outer Limits 4x4 Board

Beadlocked rims drawings or info

Who is online