Hi My 1st Post.
With out the debate over how good the result will be, I've read the other stuff. I've been told the 1UZ-fe will bolt upto late 80series Belhousing.
Any info would be appreciated
BJ42OZ 80series 1HZ MTQ turbo, Lockers F/R Brawn 4x4 ZR-9500 winch Soon massive intercooler
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1UZ-FE into 80 series
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Dont think so...i thought that too...the bell off a v8 100 series is thesame bolt pattern as the 1uzfe...the 1fzfe and 1uzfe are supposed to be from thesame family of motor, and the bells look close, but the starter on the v8 is in the valley and the 6 is on the pass side.
Soooo if you were wanting to run auto, the first gxv 100 had a a442 auto as in the 80...swap bell and your on a winner...same with 5 speed h151 in both 100v8 and 80 4.5.
Incidently Toyota quoted me $750 for the bell when i was thinking of the swap from a 3f.
Andrew
Soooo if you were wanting to run auto, the first gxv 100 had a a442 auto as in the 80...swap bell and your on a winner...same with 5 speed h151 in both 100v8 and 80 4.5.
Incidently Toyota quoted me $750 for the bell when i was thinking of the swap from a 3f.
Andrew
Who is online
Users browsing this forum: No registered users and 40 guests