Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

82 yota steering fouling U bolt

Tech talk for Hilux

Moderators: toaddog, Elmo, DUDELUX

Post Reply
User avatar
Guy
Posts: 10366
Joined: Thu Dec 12, 2002 8:43 am
Location: Wangaratta

82 yota steering fouling U bolt

Post by Guy »

After a bit if stuffing around I have noticed that the drag link (litle arm from the steering box to the U arm on a stock lux) is hitting the rear most u bolt
i will be removing a few leaves to softern the front up a bit making the pack that bit thinner, hopefully stopping the bind. (at least until I go crossover)

If I find the front end to soft, is there a special low profile U bolt I can use ?? (the springs are kings I think and are very little lift, may even be stock height replacement)
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Top
Posts: 7230
Joined: Mon Oct 21, 2002 10:42 pm
Location: Brisbane

Post by MissDrew »

Yes there is a flat topped u bolt yo can get, ARB sell em. Once you get good flex out of a hilux front you need to change both u bolts but one is ok for basicly stock springs.
Top
User avatar
Guy
Posts: 10366
Joined: Thu Dec 12, 2002 8:43 am
Location: Wangaratta

Post by Guy »

Thanks guts .. will give em a call tommorow ..
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Top
Posts: 1084
Joined: Sun Apr 04, 2004 9:33 pm
Location: Aotearoa

Post by J Top »

Sometimes the ARB U bolt wasn't enough and we used to cut the bump-
stop mount plate on a 45degree angle so it located under the curve of the rear U bolt and fully under the front one, allowing the rear U bolt to drop another 6mm.
J Top
Top
Post Reply

Return to “Hilux”

Who is online

Users browsing this forum: No registered users and 0 guests