. But can't do that with the rear. Any ideas , and no I can't just remove the swaybars, tried that and it handled like poo
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
80S sway bar dissconnects, pics now
Moderators: toaddog, Elmo, DUDELUX
80S sway bar dissconnects, pics now
has anyone used swaybar dissconects on an 80 series, the ones i've seen pics of on other vehicles have a removable pin on the locating rod but this would allow the swaybar to nearly drag on the ground. Was thinking of removing the nut on the bolt that holds the swaybar to the front diff drilling through the bolt and fitting a pin to hold it in then make a bracket to secure it to the chassis when off road . But can't do that with the rear. Any ideas , and no I can't just remove the swaybars, tried that and it handled like poo
. But can't do that with the rear. Any ideas , and no I can't just remove the swaybars, tried that and it handled like poo
Last edited by red80 on Mon May 02, 2005 5:46 am, edited 1 time in total.
I am making a similiar pin for the front swaybar so it can be fixed to the chassi when I dont need it. I've been driving around with no rear swaybar for 2 years now, I dont think the handling is to bad. But I have been thinking about refitting it and just disconnecting one side, not sure how this will affect wheel travel though.
Who is online
Users browsing this forum: No registered users and 6 guests