I was reading on another site (Ausjeep) about resetting ECU/ECMs after modifying exhausts/air intakes etc, so that it takes into account the new changes. For the jeep they say disconnect the battery and turn the ignition to remove residual power/current. Reconnect and drive normally for 15mins to allow it to gather new settings.
Does this work for a 90 sierra??
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Resetting ECM
Resetting ECM
90 Zook (My toy)
02 KJ Cherokee (Her transport)
02 KJ Cherokee (Her transport)
Who is online
Users browsing this forum: No registered users and 4 guests