Hi, all I have 2LT Toyota surf not long had the turbo rebuilt and the pump rebuilt due to being worn out.
Nevertheless, my problem is I do not seem to have any power.
I have checked the compression changed all the filters checked the pump timing its just dam slow and on hills you have to rev and ride the clutch to get going otherwise it stalls same in high range 4wd when in mud.
Any ideas on why
My friend has a non-turbo 2.4 and that would over take me?
I cannot work it out
Hope someone has ideas
Cheers Brendon
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
No guts no glory
Moderators: toaddog, Elmo, DUDELUX
No guts no glory
Cheers
Brendon
2008 nissan patrol
Factory bullbar with 12000lbs ironman winch, PLESSEY_MTR96_UHF 100ch 25watts
needs diff lock F/R
Brendon
2008 nissan patrol
Factory bullbar with 12000lbs ironman winch, PLESSEY_MTR96_UHF 100ch 25watts
needs diff lock F/R
you need to fit up a boost gauge and an EGT gauge, then tune the settings on the fuel pump for optimum power with acceptable exhaust temperatures. if the pump has been calibrated on the lean side, it will take a fair bit of adjustment to get it to make good power. almost make sure the boost compensator line is attached (from manifold to top of fuel pump). Tune it for about 600 - 650 C post turbo, and about 9psi boost. it will go surprisingly hard with that setup. If you add an intercooler 11 - 12psi is fairly safe.
if any or all of that is beyond your skills and toolkit, it would be a good idea to take it back to the shop where you had the pump rebuilt and tell them you'r enot ahppy with the power.
if any or all of that is beyond your skills and toolkit, it would be a good idea to take it back to the shop where you had the pump rebuilt and tell them you'r enot ahppy with the power.
Free air locker to the first 20 callers!
When you say adjustment do you mean the mixture screw i.e. enrichment
Alternatively, the top screw for the bellows to enable more fuel to flow under boost ???
Also I was wondering about the temp your saying 600 to 650c where do I take that temp from ??? Eg from the turbo housing or from the rear of the car ?? And is the temp reading under load or at idle ??
I have had a boost gauge on the 4wd just after having the pump rebuilt it was showing a steady 7-8 psi but unsure what the actuator has been set to when I got the turbo rebuilt I believe he set it for 10psi but unsure.
Alternatively, the top screw for the bellows to enable more fuel to flow under boost ???
Also I was wondering about the temp your saying 600 to 650c where do I take that temp from ??? Eg from the turbo housing or from the rear of the car ?? And is the temp reading under load or at idle ??
I have had a boost gauge on the 4wd just after having the pump rebuilt it was showing a steady 7-8 psi but unsure what the actuator has been set to when I got the turbo rebuilt I believe he set it for 10psi but unsure.
Cheers
Brendon
2008 nissan patrol
Factory bullbar with 12000lbs ironman winch, PLESSEY_MTR96_UHF 100ch 25watts
needs diff lock F/R
Brendon
2008 nissan patrol
Factory bullbar with 12000lbs ironman winch, PLESSEY_MTR96_UHF 100ch 25watts
needs diff lock F/R
Who is online
Users browsing this forum: No registered users and 1 guest