Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

What does your sierra weigh??

Tech Talk for Suzuki owners.

Moderators: lay80n, sierrajim

Post Reply
Posts: 22
Joined: Fri Dec 06, 2002 12:34 pm
Location: Sydney

What does your sierra weigh??

Post by Zookymatt »

Ok guys, we often talk about the light weight advantage of the sierra and there is always a debate over using a heavier drivetrain.

I weigh 1280kg with the setup that you see in my sig (effectively a hilux drivetrain), including an extremely heavy spare (it was a split rim), ARB winch bar, recovery gear, pissy 4 point lcage and towbar etc. Now compared to a similarly equiped hilux I'm still extremely light. I guess most hilux's on 33's with bars etc would be around 1700-1900kg mark??

If we are varying in weights between say 950kg and 1400kg, then we are still much lighter than most other 4wd's out there. But most modified sierra's would be most likely around the 1100kg and up, so is this 300kg range really going to make a huge difference offroad and spoil the "lightweight advantage".

So, let us know what your drivetrain is, tyre size etc. and as accurate as possible weight.

Regards,
Matt.
Posts: 2817
Joined: Fri Feb 21, 2003 10:10 pm
Location: Hellbourne again

Post by bigsteve »

My zook is quite light..............................until I get in it (130kg)

At a guess I'd say only 100 extra kgs in gear/barwork.

What does a WT Hard top Weigh normally??
yeshemesh
Posts: 3269
Joined: Mon Nov 25, 2002 1:11 pm
Location: melting gears

Post by greg »

i'm not sure what mine weighs now, but i know we're going to strip it down as much as possible to get it as light as we can. once that happens, i guess i'll go and get it weighed somewhere to get an answer for yoy :)
DMA Founding Member #1 - Now Retired
User avatar
stu
Posts: 913
Joined: Wed Jan 22, 2003 8:08 am
Location: brisbane

Post by stu »

in comparasin my car would be considered stock, well stock 1.3 motor with some extra stuff, all suzuki drivetrain (with rockhopper - weight difference will be bugger all), suzuki axels and diff with 31's, ive also taken out the rear seats (up for sale) so i'm only guessing but i'd say i'd be under the standard weight if not dead on it.

i.e add weight for larger tyres, minus weight for no rear seats
i don't need no stinking quote for my sig. line!
Posts: 3269
Joined: Mon Nov 25, 2002 1:11 pm
Location: melting gears

Post by greg »

dare i ask where i regular person would weigh their car?

i.e. someone that does not have access to a weigh bridge normally.
DMA Founding Member #1 - Now Retired
Posts: 4882
Joined: Fri Nov 08, 2002 8:36 pm
Location: Medowie, NSW

Post by redzook »

our local dump has a car wigher :?


u can try there :wink:
Posts: 13555
Joined: Fri Nov 15, 2002 1:28 pm
Location: Melbourne

Post by grimbo »

I'd be interested to find out too. everytime I go past one of those weigh bridge thingys I would love to have a go
Ransom note = demand + collage
Posts: 3443
Joined: Tue Oct 29, 2002 10:50 pm
Location: Currently On the Road !!

Post by Dozoor »

JUst take a load of your shit to the tip in the back ,when you pay get the docket , it has the wieght at entry and at depature.
extra 300kg , maybe grab three freinds at about 100kgs's each do a tough bit of trail , then do it without the blobs, It does make a difference.
but if the wieght is in the right spot like a set of stronger diffs i think its probly a good point as the c/o/g is lowered as well as getting a wider track and stronger axles/ cvs ect. :)
Posts: 2817
Joined: Fri Feb 21, 2003 10:10 pm
Location: Hellbourne again

Post by bigsteve »

greg wrote:dare i ask where i regular person would weigh their car?

i.e. someone that does not have access to a weigh bridge normally.


I might be able to organise this, I'll let you know.
yeshemesh
Posts: 2296
Joined: Thu Oct 24, 2002 4:30 pm

Post by OVERKILL ENG »

I havn't had mine on a weighbridge but on paper it weighs about 800kg.
I might be getting it corner weighed next week so I'll let you know.A mate has a set of corner scale as he does a lot of race cars so I will be able to tell how much weight is on each wheel. :D
OVERKILL ENGINEERING
www.overkill4x4.com
Posts: 22
Joined: Fri Dec 06, 2002 12:34 pm
Location: Sydney

Post by Zookymatt »

It would be great to use a corner scale and find out what the weight distribution is.

The weighbridge that I've used is around the corner from where I get my sierra certified. Its just a truck depot with large silos full of cement product of some sort. So the trucks drive in, get weighed, load up and weigh out again. You just pay $10, drive on and pick up the printout from the window. I have wondered about the accuracy. It would have to be reasonably accurate but the 1280kg would be a fairly small amount of its total scale, say 40 or 60 ton or so (is the 40ton for semis their load capacity or is it the gross vehicle mass??).

Actually, I weighed my sierra at 4 stages over several years. I will find my weigh tickets tomorrow and post the results, but I can tell you the stages now.
I think I had the ARB bar, 4 point cage and towbar on the whole time.
Stage 1- SPOA probably weighed with 235/75's
Stage 2- as above with efi vit motor, probably also weighed with 235/75's
Stage 3- as above with hilux diffs, definitely weighed with 32" BFG's
Stage 4- current setup with 33" swampers.

If you have a tip nearby that has a weighbridge, they would probably charge you $5 or something just to get a readout and not actually dump any rubbish.

Regards,
Matt.
Posts: 4065
Joined: Thu Oct 24, 2002 8:31 am
Location: ACT

Post by Wendle »

overkill wrote:I havn't had mine on a weighbridge but on paper it weighs about 800kg.
I might be getting it corner weighed next week so I'll let you know.A mate has a set of corner scale as he does a lot of race cars so I will be able to tell how much weight is on each wheel. :D


you could just sit that thing on 4 bathroom scales...
Posts: 3288
Joined: Sun Feb 02, 2003 10:15 pm
Location: Central West NSW

Post by Slunnie »

I dont know what my zook weighs, but the Disco went on the weigh bridge ($10 I think) when I was designing the suspension and it came in at 2300kg which I thought was interesting as the paper work states 2050kg. The only heavy add were a bar, barrier, full tank and dog. I'm sure the bar isn't 250kg!
Cheers
Slunnie

Discovery TD5, Landy IIa V8 ute.
Posts: 2296
Joined: Thu Oct 24, 2002 4:30 pm

Post by OVERKILL ENG »

Wendle wrote:
overkill wrote:I havn't had mine on a weighbridge but on paper it weighs about 800kg.
I might be getting it corner weighed next week so I'll let you know.A mate has a set of corner scale as he does a lot of race cars so I will be able to tell how much weight is on each wheel. :D


you could just sit that thing on 4 bathroom scales...



thats a thought I might try it
OVERKILL ENGINEERING
www.overkill4x4.com
Posts: 329
Joined: Thu Nov 07, 2002 5:24 pm
Location: Brisbane

for reference

Post by derangedrover »

so you lightweight guys have a reference.

I weighed my rig when I bought it as a reference for mods etc

scales were certified set at a local scrap yard.

stock 89 Range Rover Vogue, 5 speed, alloys 205R16's, basically factory other than LPG

2000kg, no driver, full tanks (60lt LPG, 80lt fuel)
1100kg rear axle
900kg front axle

Cheers
Daryl
Post Reply

Who is online

Users browsing this forum: No registered users and 49 guests