Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

80 series body cracks

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 204
Joined: Wed May 25, 2005 6:18 pm
Location: Karratha Western Australia

80 series body cracks

Post by shanegtr »

anyone experienced cracks in the body. Looking at mine I have cracks at the very back at the top corners of the rear door - both sides. The C pillar is ok and free from cracks.
Posts: 2097
Joined: Tue Aug 12, 2003 6:50 pm
Location: wollongong

Post by dow50r »

check out the tech pages on www.lcool.org.....yours has obviously seen some rough tracks
Andrew
Posts: 156
Joined: Mon Dec 09, 2002 10:25 am
Location: Canberra

Post by Roktruk »

My 80 belonged to a surveyor that worked at Olympic Dam in SA, so it did most of its first 130k on red dirt. It has cracks in the rear corners of both doors, where the gutter ends. They haven't grown noticeably at all in the past 7 years (another 130k) so I'm not concerned at all.

The lower lock mechanism on the big rear door had rusted due to a leaking washer tube, so the whole door was only being held by the upper lock. The loop was badly worn. I replaced these shortly after I bought it, so maybe this was the cause of the cracks.

%$#@$ still squeaks though :x
Posts: 2097
Joined: Tue Aug 12, 2003 6:50 pm
Location: wollongong

Post by dow50r »

To get peace and quiet, wrap electrical tape over the steel round thing the latch grabs up top.
Toyota sell a $75 plastic coated one to stop the caneries
Alternately buy some silicon spray and each time you open the door, spray the latch a bit.
Andrew
Posts: 204
Joined: Wed May 25, 2005 6:18 pm
Location: Karratha Western Australia

Post by shanegtr »

dow50r wrote:check out the tech pages on www.lcool.org.....yours has obviously seen some rough tracks
Andrew
I dont hold back. I've done alot of dirt roads up here. All my back door latches are stuffed and need replacing too
Posts: 233
Joined: Sat May 14, 2005 4:59 pm
Location: newcastle

Post by mico »

my 4runner has the same cracks above the rear door wouldn't be to worried bout it it's only caused by the body twisting (i think the roof and rear quarter joins there)
if it ain't broke send it to me i'll fix it!
Posts: 204
Joined: Wed May 25, 2005 6:18 pm
Location: Karratha Western Australia

Post by shanegtr »

but when it rains it lets water into the car and down into the cargo area, which has in turn rusted out the two bottom corners of the floor. It has pretty severe cracks, I can move the back section of the roof about 1-2mm at the crack!!!!
Posts: 2590
Joined: Tue Jan 04, 2005 11:33 am
Location: Brisbane

Post by Chucky »

dow50r wrote:To get peace and quiet, wrap electrical tape over the steel round thing the latch grabs up top.
Toyota sell a $75 plastic coated one to stop the caneries
Alternately buy some silicon spray and each time you open the door, spray the latch a bit.
Andrew
I'll try this. But my small rear door comes slightly open when I drive over anything rough. It won't swing open or anything but you have to push on the large door for the small one to unlatch and swing open.
Anyone have any clues as to why this happens?


Sorry about hijacking the thread. :oops:
My Cruiser is Environmentally Friendly.

It runs on recycled Dinosaurs.
Post Reply

Who is online

Users browsing this forum: No registered users and 66 guests