Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

grounding/humming noise??

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Post Reply
Posts: 181
Joined: Thu Apr 14, 2005 12:09 pm
Location: Geelong VIC

grounding/humming noise??

Post by Glennb »

On the weekend I did something stupid and went through a very deep bog hole, so deep the water was higher than the engine. you can see the water mark on top.

The problem is now I have this grounding/ humming noise from the left side of the engine.Can notice it mostly in the cabin in the passanger side floor, towards the front.
The noise happens in idle and gets louder when I rev the engine, but will fade out when the revs get real high.Also noisy when driving.@ 100ks can just notice it. :cry:

Anybody got any idea :?:

Cheers
Glenn
Posts: 1130
Joined: Thu Nov 18, 2004 7:25 pm
Location: New Zealand

Post by NJV6 »

HI,
Could be bearings in an idler pulley or maybe alternator? I know mine were grrowley, replaced a noisy bearing and it was still there, there was a real symphony going on, I also did the alternator bearings, quietned things up no end. And I found it is a real mission to get alternators out of 3.5's!
Posts: 728
Joined: Sun Aug 24, 2003 8:46 pm
Location: Canberra (too far from the sea)

Post by twinnie »

it could be the starter motor if you notice it in the cab mostly.

Matt
Posts: 2739
Joined: Sat Oct 26, 2002 7:50 am
Location: Melbourne

Post by Bitsamissin »

Yes sounds like the dreaded idler pulley whine..............
Is it left hand side sitting in the drivers seat or looking under the bonnet ??
I just luv my "clacker Jabber"
Posts: 408
Joined: Thu Sep 25, 2003 1:21 pm
Location: "Shit"ney

Post by Noisey »

If you have air con check for crap trapped between the pulley and the main body of the unit.

Pulley bearings gone or even the main bearing in the air con unit itself.

Easiest way to tell is to remove the fan belt from the air con and start the car up - you will tell straight away.
When I read about the evils of drinking, I gave up reading
Posts: 181
Joined: Thu Apr 14, 2005 12:09 pm
Location: Geelong VIC

Post by Glennb »

CHEERS GUYS
YES ITS THE AIR COMPRESSOR, THE BEARINGS :cry: DROPPED INTO MITSU ON THE WAY HOME. WHEN THE AIRCON IS OFF ITS NOISY THEN WHEN ITS ON IT GOES AWAY TILL IT SWITCHES BACK OFF.
I WAS TOLD MAYBE ABLE TO REPACK IF THERE IS NOTHING WRONG WITH IT. BUT IF THERE IS $1200 DOLLAROOOOS :x FOR A NEW ONE.

ANYBODY NO HOW MUCH IT WILL COST ME TO HAVE IT PULLED APART AND REPACKED WITH NEW BEARINGS??
CHEERS
GLENN

ALSO WHY DID THIS HAPPEN? IVE BEEN THROUGH LOTS OF BOG HOLES AND NEVER HAD THIS PROBLEM?
Posts: 408
Joined: Thu Sep 25, 2003 1:21 pm
Location: "Shit"ney

Post by Noisey »

The bearing itself is only about $20 or so bucks from CBC. You will have to release the gas (have someone do it) and remove the unit from the car. Use a bearing puller to remove the Pulley and bearing (fairly easy) and replace.

Get regassed.

or

Fug the air con off and convert the system to an air system.

I run twin air con units - one for a/con and one for air - best of both worlds apart from the air con leaks and I am too tight to pay to get it fixed so I just drive with the windows down and me head hanging out slobbering at the oncoming traffic. :lol:
When I read about the evils of drinking, I gave up reading
Posts: 167
Joined: Wed Jul 21, 2004 10:23 pm
Location: Tassie

Post by GREGGO »

I just drive with the windows down and me head hanging out slobbering at the oncoming traffic.
I'd hate to meet you coming the other way!! That avtar of you is mightily scarey!!! :lol: :lol:
Shorty Gen2, lots of stuff and more to come!
Posts: 180
Joined: Wed Aug 18, 2004 7:57 pm
Location: packahoonaham

Post by corkhead »

id hate to meet you the other way GREGGO .... cos by your avatar you wouldnt see me through that wall of water :)
www.victoriancampertrailers.com.au
www.salon13.com.au
Posts: 181
Joined: Thu Apr 14, 2005 12:09 pm
Location: Geelong VIC

Post by Glennb »

Cheers noisey, so it shouldnt be much more than a couple of hundred.think it needed regasing anyway.
Posts: 167
Joined: Wed Jul 21, 2004 10:23 pm
Location: Tassie

Post by GREGGO »

Hey corkhead, that's the wife driving......
Shorty Gen2, lots of stuff and more to come!
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest