Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Body lift

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 168
Joined: Sat Aug 27, 2005 10:28 am

Body lift

Post by mangie »

G'day
It would seem that the 40mm body lift I have is not going to be enough to stop rubbing my 35/11.5/15 Simexs, I'm thinking 60mm (about 2.3 inchs) is what I'm after. My question is, should I go aluminium or nylon and what grade nylon would I need? Any comments would be most helpful.
Top
Posts: 1606
Joined: Sat Oct 26, 2002 7:20 pm
Location: Geelong

Contact:
Contact HSV Rangie

Post by HSV Rangie »

aluminiumn or steel

Michael.
Mitsubishi 2010 NT DID Pajero wagon, Factory rear diff lock, Dual batteries, ARB bar, winch, Mt ATZ 4 rib tyres.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
Top
Posts: 2526
Joined: Wed Sep 01, 2004 8:21 am
Location: Outcast Offroad

Post by Micka »

Maybe some 30mm coil spacers will give you that extra bit of clearance.

The fronts are a pain to do, but it is a lot quicker and cheaper than redoing a body lift.

Micka
Top
Posts: 268
Joined: Tue Apr 19, 2005 7:00 pm
Location: Brisbane

Post by Rangie ute on 38'' »

i had same problem so i put 30mm coil spacer in the rear and it works, that way your not exceeding the 2'' body lift (if that maximum rule still applies), lot less effort
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 2 guests