Was considering a bit of a shave to the lower bumpstops today as even under full compression the front tyres do not enter the guards. Removed the torsion bars completely and dropped the car to the ground to get an idea of clearance. Noticed that both the Pitman and Steering arm come into contact with the front sway bar before I get any real compression of the bump stop.
What a bummer! With body lift and suspension lift (wll over 4 inches combined) I thought extending the sway bar connects by two inches would be ample - in the end it has been too much. Bit more chopping required but I'm guessing 1 inch will do the job nicely.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Contact !
Moderator: -Scott-
causes insurance issuesMiyagi wrote:would removing the front sway bar cause any real big issues? i've taken out my rear sway bar and the car feels better for it....
MK (MY04) Triton GLS
31" BFG A/T
40mm torsion bar crank
[size=75]You should make a point of trying every experience once ... except incest and folk-dancing.[/size]
31" BFG A/T
40mm torsion bar crank
[size=75]You should make a point of trying every experience once ... except incest and folk-dancing.[/size]
I'll show you the difference on Saturday Miyagi - running sway bar then disconnecting (thanks to franks' articulator)
I ran around for about 6 months without front and rear sway bars. The rear I never put back in but without the front the vehicle cornered like a boat. During this time I also destroyed CV boots more often than I changed my undies. The ride is a lot softer - especially off road but the cons are crap handling and far more front end wear.
I ran around for about 6 months without front and rear sway bars. The rear I never put back in but without the front the vehicle cornered like a boat. During this time I also destroyed CV boots more often than I changed my undies. The ride is a lot softer - especially off road but the cons are crap handling and far more front end wear.
When I read about the evils of drinking, I gave up reading
Re: Contact !
It's been noted before in trimmimg bumpstops that it isn't recommended to alter the lower bumpstops( upward travel eg stuffing the wheel) There's a post somewhere in ancient history here on it.Noisey wrote:Was considering a bit of a shave to the lower bumpstops t.
Only trimming the upper bumpstops to allow more droop has ben successful,
In relation to your experiment on compressing the lower bumpstops, you'd have to be getting some serious air or have completely stuffed T/bars and shocks, in order to get both sides to compress enough to reach the bump stops simultaneously.
Try the experiment only stuffing one wheel while the other is about normal extension see if the results are the same?
NF 3.0 BLK, 2.5" suspension (HD T bars, prog coils, TJM Bullbar, 31X10.5X15 Mickey T FCII & cent locking
Who is online
Users browsing this forum: No registered users and 20 guests