Bang Again

Website · Post by **Maggot4x4** » Sun Sep 11, 2005 5:21 pm

Having blown up my second tailshaft in a month, both times the the front flange on the rear shaft, I need sugestions. This shaft cost $420 and had 30deg flanges with 1310 uj's, the flange just exploded an a very mild hill climb, low first and about 1200rpm.

I was going to go 1350 uj's but they were only in a 20deg flange as it was the uni that let go last time.

For those that don't know the specs of the truck, it's an 85 Rangie with 4BD1, LT85, LT230, GQ diffs with 4.1's and 35" Simex ET's.

How hard would it be to redo the flange on the outpit shaft to take a GQ bolt patern, and would it fit in the handbrake?

The shaft was less than 24hrs old and all it did was drive the 30km to the track and the forrest track once there.

Help please, as I want to turbo the truck but if I cant keep tailshafts in it now, what hope do I have with a turbo!

Post by **Rangie ute on 38''** » Sun Sep 11, 2005 8:40 pm

its sounds like an alignment prob, do you have nissan diffs. having a brand new shaft and that happening in that situation sounds strange.

Post by **Philip A** » Mon Sep 12, 2005 10:03 am

You must add the angles when computing the total angle on the UJ.

IE you must add the offset caused by the GQ diff being in the middle to the down angle to find the true angle on the UJ.

Sounds like it may be more than the design max. It sounds wrong but I read it on a US driveshaft makers site so it MUST be correct.
regards Philip A

Post by **red90** » Mon Sep 12, 2005 10:53 am

Remember, you need to look at the angles at full suspension travel.

Post by **red90** » Mon Sep 12, 2005 10:54 am

Remember, you need to look at the angles at full suspension travel.

You probably need to go double cardon, not stronger.

Post by **HSV Rangie** » Mon Sep 12, 2005 11:05 am

Alll the info you need on drive shafts.

http://www.pirate4x4.com/tech/billavist ... index.html

Michael.

Website · Post by **Maggot4x4** » Mon Sep 12, 2005 5:11 pm

Thanks guys, will check out the link.

Here is a photo of the now dead flange.

Post by **redzook** » Mon Sep 12, 2005 5:18 pm

can u see any where where it has been binding?

Website · Post by **Maggot4x4** » Mon Sep 12, 2005 5:36 pm

No binding at all

Post by **DARTHrover** » Tue Sep 13, 2005 4:42 pm

if i had to guess! ide say sh%t cast quality.
or poor spline design(as that is where it broke)
as a machinist, if you dont finish a spline off properly it will
shear easy as!
and being a cheap quality cast thats what i bet on.

Post by **red90** » Wed Sep 14, 2005 5:26 am

OK, I'm confused. You said the flange broke. That looks like the shaft broke. U-joint didn't break, do that is not the problem.

Unless the shafting is complete crap, then something must be binding or hitting. From what I can see the shaft should be stronger than the UJ.

Outer Limits 4x4 Board

Bang Again

Bang Again

Who is online