This one has no doubt been mentioned before but the blower fan on my
'96 Sportrak (Feroza) is faulty.
I know all about blowing resistors and have replaced one already (as described in FAQ) but still getting nothing, totally dead.
Is there a relay somewhere that might be shot?
Ideally I'd like to have the blower working properly
any advice is appreciated.
I hope to God it's not a dashboard off job
Cheers,
Jon (England)
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Blower fan
Moderator: Tiny
Feroza blower fan
Fan is dead on all switch positions.
Some bright spark has previously bypassed with a toggle switch wired from the battery directly into the blower connections thus giving full blast or off, I intend to have the original fan switch working.
I've check the terminals in the switch multi-plug and got some continuity faults, so the 4 position switch is suspect. I'm looking into a replacement from the local Daihatsu dealer.
Also I'm getting no voltage from the corresponding other half of the multi-plug. After looking in the engine bay the fusible link from the battery marked "CDS FAN 30A" is missing. Is this the one that provides juice to the blower? or am I barking up the wrong tree?
So, I'm slowly making progress but as I'm no auto electrician a bit of guidance will help.
Cheers,
Jon
Some bright spark has previously bypassed with a toggle switch wired from the battery directly into the blower connections thus giving full blast or off, I intend to have the original fan switch working.
I've check the terminals in the switch multi-plug and got some continuity faults, so the 4 position switch is suspect. I'm looking into a replacement from the local Daihatsu dealer.
Also I'm getting no voltage from the corresponding other half of the multi-plug. After looking in the engine bay the fusible link from the battery marked "CDS FAN 30A" is missing. Is this the one that provides juice to the blower? or am I barking up the wrong tree?
So, I'm slowly making progress but as I'm no auto electrician a bit of guidance will help.
Cheers,
Jon
It could be the Heater Relay.
Here's a link to the Body Electrical .pdf manual if you need it. I found some info on page 85 of that download that'll help you with checking your switch.
Page 4 shows where the Heater Relay is.
The "CDS FAN 30A" is for the A.C. relay, I don't know if that goes to the fan switch somehow.
I'd say take the fuse "AM2" from it's slot and put it into the "CDS FAN" slot and see if your blowers work then. The "AM2" (40A) fuse is for your lighting switch so do this just to see if it works.
Here's a link to the Body Electrical .pdf manual if you need it. I found some info on page 85 of that download that'll help you with checking your switch.
Page 4 shows where the Heater Relay is.
The "CDS FAN 30A" is for the A.C. relay, I don't know if that goes to the fan switch somehow.
I'd say take the fuse "AM2" from it's slot and put it into the "CDS FAN" slot and see if your blowers work then. The "AM2" (40A) fuse is for your lighting switch so do this just to see if it works.
[url=http://dougfreeze.com/daihatsu]DougFreeze.com/Daihatsu[/url]
Thanks for the reply Doug, I already have the full service manual on pdf
and checked the my switch against the continuity table and found faults.
A new unit is £65 from Daihatsu, you have to buy the whole thing
i.e. (hot/cold - fan - air distribution - fresh/recirculated air) as one console,
hopefully the faulty switch is the root of the problem.
Looks like it's dashboard out to fit it though - shit!
I can't find the heater relay at all, it's not where the manual puts it.
All I can see is the fuse box, no relays in either footwell.
Perhaps the '95 onwards UK spec doesn't have one?
Any idea where the live supply to the heater fan is?
Cheers,
Jon.
and checked the my switch against the continuity table and found faults.
A new unit is £65 from Daihatsu, you have to buy the whole thing
i.e. (hot/cold - fan - air distribution - fresh/recirculated air) as one console,
hopefully the faulty switch is the root of the problem.
Looks like it's dashboard out to fit it though - shit!
I can't find the heater relay at all, it's not where the manual puts it.
All I can see is the fuse box, no relays in either footwell.
Perhaps the '95 onwards UK spec doesn't have one?
Any idea where the live supply to the heater fan is?
Cheers,
Jon.
Who is online
Users browsing this forum: No registered users and 11 guests