Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Water Leak in GQ body

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 343
Joined: Fri Jun 18, 2004 3:25 pm
Location: Melbourne

Water Leak in GQ body

Post by EricB »

Hi

I have a GQ SWB that likes to collect water. When it rains heavily water often drips on your feet, drivers side and passenger. I little never bothered me until i heard water sloshing around when i braked. I thought it must have been a water container that i had in the car. ;) But when i heard it and there were no water containers i was worried. Some of the water ended up in the sill under the drivers door. The carpet was wet along it and there was a slow leak under it outside the car. Looking outside along the sill I found small drain holes that were full of mud and after clearing about a litre of water came out.

Where are the main problems with water leaks when it comes to GQs?

Has anyone else had this problem?

Cheers
Eric
2000 GU II 4.2TD
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Re: Water Leak in GQ body

Post by bogged »

EricB wrote:Where are the main problems with water leaks when it comes to GQs?
there is a drain in the windscreen rubber on outside that directs water dwon into the grill bit infront of screen.. It gets blocked, and water comes in down firewall.
Posts: 343
Joined: Fri Jun 18, 2004 3:25 pm
Location: Melbourne

Post by EricB »

Cool, what is the best way to clear it?

Do I have to take the grill bit off?
2000 GU II 4.2TD
Posts: 1552
Joined: Wed Dec 22, 2004 12:09 pm
Location: im at wello point

Post by bilby »

check the ones under ya doors too ! they mite be full of water
just a little left of insanity :)
Posts: 343
Joined: Fri Jun 18, 2004 3:25 pm
Location: Melbourne

Post by EricB »

I had the door trim and the rear side trim off a little and they were dry.

The carpet under my floor mat was real wet too.
2000 GU II 4.2TD
Posts: 368
Joined: Tue Jan 18, 2005 12:06 am
Location: scotland

Post by lexi »

sounds like a windscreen rubber or blocked drain hole Water hose and an assistant are the time honoured methods of investigation. Hey fella now you know what like it is drivin a Rover :D . Only thing is it finds it `s way out of Rover as quick as it gets in.
Alex
Posts: 2311
Joined: Fri Sep 09, 2005 11:08 am
Location: Bendigo

Post by kirragc »

had a similar problem
found the windscreen rubbers were poorly sealed.
Little bit of sealant around the top and bottom corner did the trick.
What, haven't you ever done lines of International Roast off a hookers back with $100 notes?
Posts: 343
Joined: Fri Jun 18, 2004 3:25 pm
Location: Melbourne

Post by EricB »

Yeah I have already sealed the sides and top of the ribber with silicone.

Sometimes you can see the water pool on the inside of the screen in the corner of the rubber.
2000 GU II 4.2TD
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

The drains are an inch or 3 in from the sides on the bottom.
there is actually a small hose on some (1/4cm - 1/2cm diameter), but if screen has ever been replaced, you can bet its gone. They direct the water down into the grill bit infront of screen

Also if the screen has been resealed with silastic it will probably be blocked.

I'll see if I can get a photo later when I get home.
Posts: 343
Joined: Fri Jun 18, 2004 3:25 pm
Location: Melbourne

Post by EricB »

I found some small hoses that sound like the ones that you are talking about. I cleared them and will see how it goes.

I still wonder why water gets on that side of the rubber, why cant it just stay on the outside ? :roll:
2000 GU II 4.2TD
Posts: 446
Joined: Wed Jun 30, 2004 12:14 pm
Location: Perth

Post by bulldogy »

Having same problem with mine .
Farkin givin me the shits new screen silastic all the way around both sides of seal pipes to drain seem clear but mine is just the pass side.
Thinkin may take front carpet out and get a spray on rubber coating drill a few holes and bung them then if it comes in just unplug.
Anyone know a good sray on polyurethane like rhino lining etc but that you can do yourself?
Cheers Dave
Posts: 343
Joined: Fri Jun 18, 2004 3:25 pm
Location: Melbourne

Post by EricB »

The bad thing about it coming in is as soon as it rains a lot the car fogs up like a B*stard. As well as the wet floor. :lol:
2000 GU II 4.2TD
Posts: 1072
Joined: Thu Jun 17, 2004 4:38 pm
Location: Port Macquarie

...

Post by JemmyBubbles »

I didn't know mine did it... Until I decided to yank carpets out not only was there surface rust on the floor but the carpets were rotten and stinky :bad-words:...

...Still haven't done anything about it though.....
[quote="MSCHIF"]SPUA its like shaving a barbie dolls head, amusing but pointless.[/quote]
Posts: 176
Joined: Wed Jun 09, 2004 8:43 pm
Location: South Brisbane

Post by shortgq »

Mine did the same.... leaked at the bottom of the screen in both corners.... bought non-geniune rubber from windscreens obrien, some non setting silastic and no leaking since :armsup:
Posts: 79
Joined: Thu Jun 16, 2005 10:54 am
Location: In Hell !!!!!!!!!!!!!

Post by stevelb1 »

shortgq wrote:Mine did the same.... leaked at the bottom of the screen in both corners.... bought non-geniune rubber from windscreens obrien, some non setting silastic and no leaking since :armsup:
How much did they hit you up for the new rubber, would Sikaflex be ok to use instead to seal the screen.
Cheers.....Steve

Never argue with an idiot, as others listerning may not be able to tell the difference.
Posts: 343
Joined: Fri Jun 18, 2004 3:25 pm
Location: Melbourne

Post by EricB »

shortgq wrote:Mine did the same.... leaked at the bottom of the screen in both corners.... bought non-geniune rubber from windscreens obrien, some non setting silastic and no leaking since :armsup:
Did you take the screen right out to fix it?

I have sealed between the rubber and body all the way around but maybe i need to seal between the rubber and glass also.
2000 GU II 4.2TD
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests