im looking at running a 5litre air tank rated at 120PSI as per instead of a compressor, using servo's air to pump up the tank.
http://www.superiorengineering.com.au/p ... ory=6#1140
Since the ARB Air Locker works between 50 and 85 psi.
does this mean i get one chop at turning the lockers on before i lose the pressure?
i no i have slap on a regulator between the tank and the Air Locker actuating switch to prevent blowout.
cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Air lockers & air tank pressures
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Hey there
Go to Kelly's Wrecking, the truck wreckers next to the train line at Carseldine, just up from the QUT campus. They sell truck air tanks, for about $30.
Set the pressure at about 100psi max, as apparently the locker solenoids don't like much more pressure than that.
Setting up an on-board air system is dead set easy. Get the bits (pressure switch, relief valve, non-return valve etc.) from Compressor Care in Brendale. Dirt cheap. Dead easy.
Regards
Go to Kelly's Wrecking, the truck wreckers next to the train line at Carseldine, just up from the QUT campus. They sell truck air tanks, for about $30.
Set the pressure at about 100psi max, as apparently the locker solenoids don't like much more pressure than that.
Setting up an on-board air system is dead set easy. Get the bits (pressure switch, relief valve, non-return valve etc.) from Compressor Care in Brendale. Dirt cheap. Dead easy.
Regards
Big Dave, Scarborough, Qld
Loose Screws 4wd Racing Team
Loose Screws 4wd Racing Team
Who is online
Users browsing this forum: No registered users and 2 guests