hi all
the motor in my F20 (12R) is about to go well even if it doesnt it fawked and gunna cost to much money to maintain in its current state
what im after is if any one knows of any place in nsw that rebuilds 12r's or sells short 12r's or even long 12r's that have been rebuilt
or know of a 12r thats for sale that has been rebuilt not long ago
i really need to do something about my motor before its to late
i was looking at the 18r conversion but to much coin to do and i cant cus im on my P's which doesnt allow me to drive a vehicle that had engine modifiactions or anything that is seen and a performance upgrade
cheers
elliot
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
F20 and scat owners please help if you can
Moderator: Tiny
F20 and scat owners please help if you can
Last edited by runnin4life on Mon Feb 20, 2006 4:30 pm, edited 1 time in total.
, and cop the fine if you get cought 
)
The 4 and 5 speed boxes are essentially the same, the 5th gear on the 5 speed box is really just an overdrive hanging off the end off a standard daihatsu 4 speed box.
You will need the 5 speed drive shafts though, because the 5 speeds output is about 100 mm further back than the 4 speeds.
Search other posts on OL, as this, and the associated gear lever mods have been covered before.
Bell housing to put a 5 speed box onto your 12r motor?
Just use the bell housing off your old 4 speed box, it will bolt right up.
The engine mounts for the 2.8 diesel are bigger than the 12r mounts and are in a different position as it's a much bigger engine, and since you're going to be welding your chassis to fit in a 2.8, maybe that chevy v6 isn't such a bad idea after all?
As it happens I might have a reco 12r down here in Melbourne, one of my mates thought he needed it, but as it turns out I think it's just sitting around unused. Don't know what courier costs to Candida would be though.
You will need the 5 speed drive shafts though, because the 5 speeds output is about 100 mm further back than the 4 speeds.
Search other posts on OL, as this, and the associated gear lever mods have been covered before.
Bell housing to put a 5 speed box onto your 12r motor?
Just use the bell housing off your old 4 speed box, it will bolt right up.
The engine mounts for the 2.8 diesel are bigger than the 12r mounts and are in a different position as it's a much bigger engine, and since you're going to be welding your chassis to fit in a 2.8, maybe that chevy v6 isn't such a bad idea after all?
As it happens I might have a reco 12r down here in Melbourne, one of my mates thought he needed it, but as it turns out I think it's just sitting around unused. Don't know what courier costs to Candida would be though.
Who is online
Users browsing this forum: No registered users and 33 guests