Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Please help - where is the timing mark thingy!

Tech Talk for Ford, Mazda, Daihatsu & Makes that currently dont have a home.

Moderator: Tiny

Post Reply
Posts: 143
Joined: Sat Jul 16, 2005 11:18 am
Location: Brisbane Bayside

Please help - where is the timing mark thingy!

Post by drewe »

Hey all,

OK, dumb question, but I have never done this before... I am about to adjust the timing of my roza (it is crapped - I replaced the Dizzy recently) - I have all the tools, but where is this mark I am aiming my timing light at?

Do I need to remove the timing belt cover and it is one of those gears, or is it one which is out? Grrrr. I might have learned a lot recently, but still plenty more!

Dreweh
Posts: 143
Joined: Sat Jul 16, 2005 11:18 am
Location: Brisbane Bayside

Post by drewe »

Still coulnd't find it after ages, so I just advanced the timing till it almost can't go any further - runs much better :)

Of course, I am probably causing some other problem :(
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

There's a cut out notch in the front pulley edge IIRC and you should see it in between the timing markers when the light is attached to the spark plug lead closest to the front of the engine. Adjust the distributor until it is central between the markers- making sure the vacuum advance is first disconnected from the distributor and blocked off. If you're not sure which pipe it is, it's the one that has vacuum when the engine is idling (the other one won't.)

DON'T drive around with it fully advanced! Even running 98 octane fuel you will be getting detonation which will very quickly destroy your engine!!!!
David
Posts: 143
Joined: Sat Jul 16, 2005 11:18 am
Location: Brisbane Bayside

Post by drewe »

Does anyone have a photo? I can upload one of mine and someone point it out? @#$#@$ - probably just too much oil around, I just can't find anything!!!!!
Posts: 8556
Joined: Mon Jun 13, 2005 9:34 pm
Location: Sydney

Post by RockyF75 »

I like diesel :D






(sorry :oops: )
60 + Turbo, 33"s :armsup:
Posts: 165
Joined: Tue Oct 12, 2004 8:33 pm
Location: clontarf, qld

Post by inka »

while motor is not running run your finger around the front pulley edge. you should feel the little nick out of it. if at bottom of revolution just twitch your starter till it is at the top so you can see it. then go inside the house and grab either a white marker or liquid paper and mark it so you cant lose it again ;)

it will be on the closest edge to the motor
rockstock gq patrol
Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests