Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Quarter Cuts

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 75
Joined: Sat Jan 21, 2006 9:52 pm
Location: Brisbane QLD

Quarter Cuts

Post by mk swb »

Can someone please inform me of a method of cutting quarters of my mk swb. once marked then what????? where to start please help??? and i looked at the bible but no info just some pics.

Cheers Rees
20" chrom rim $3000 stainles exhast $1000 monsta tac $500 thinkn it make a lancer fuly sik priceles
Top
Posts: 3739
Joined: Sat Dec 11, 2004 10:10 pm

Post by mickyd555 »

grinder..................... :D
Top
User avatar
Tiny
Road Ranger
Posts: 10722
Joined: Fri Nov 12, 2004 12:21 pm
Location: In a town near you

Contact:
Contact Tiny

Post by Tiny »

grinder with the thinnest disk you can get, if you want to fold back mark lower, if you want to weld a plate in mark where you want the final position to be
If the above post did not offend you in any way please PM me so I can try harder!!
Top
Posts: 75
Joined: Sat Jan 21, 2006 9:52 pm
Location: Brisbane QLD

Post by mk swb »

i have marked it where i want it to end up and do i just cut it off then weld a plate inside or do i get some bent up to fit inside then weld????? Whats the go whats everyone else do???? pics???
20" chrom rim $3000 stainles exhast $1000 monsta tac $500 thinkn it make a lancer fuly sik priceles
Top
Posts: 1032
Joined: Mon Mar 17, 2003 10:14 am
Location: Newcastle, NSW

Contact:
Contact Heathx4

Post by Heathx4 »

Look in my member's thread for an example. Very common procedure.
* Nothing is foolproof to a sufficiently talented fool *
Top
Posts: 485
Joined: Wed May 05, 2004 8:04 am
Location: parramatta

Post by viperguy »

i just cut where i thought looked good with the 4inch grinder..where i cut is probly marginaly higher then most guys. i cut the middle of the v-groove in the rear quater panel. then made a template and used a nylon cutting board as my plate material. sikaflexed them in place. took all of about 1 hr.
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 115 guests