Marks 4WD/Gearmaster Portal Axles

[ISUZUROVER]

i was under the poinion that you couldnt shorten the axles because there is a drive dog on the end of one for the activation of the locker?

Andrew

There are heaps of people in the US who have narrowed mog axle casings. There are suppliers in the US who sell custom length mog axles for this purpose.

[Dyna Beast]

Hello
Looks like my old truck would be a good opotion to fit unimog axles.Motor is near mid mounted.Nothing to speak of above the fron`t diff,apart from a big space.
Cheers

[MARKx4]

and the pumpkin is just about in the center of the diff and it is 19" long. So unless u want your 4x4 to sit 10" higher u need to do some major sump mods, and/or move the engine to the right.

I knew that fitting these diffs is never going to be a easy job, but in the sump problem wouldnt you just run a dry sump like race cars do?

never done it my self (yet) but it seems the deep part of the sump isnt the problem its the front shallow section, this is where the 3rd member is at its biggest, so dry sump wouldnt help alot... I think

In that case, if you run a straight 6 you could run the dry sump and lay the motor enough to clear. Like they do to the 4cly in speedcars.

These ideas are me just thinking, im not trying to make it sound there are easy solutions because the things i have mentioned arnt that easy. Im gathering information and ideas as i wouldnt mind running these diffs. Also hopfully open up some ideas for others.