Just after some advice/info on this motor in my 75ser 85mod
ive recently rebuit mine everything was done and it seems 2 be a reel dog going up hills even the faintest hill seems to slow me down IS this normal ??? also im finding that when cold oil pressure is high wich is fine but when on a decent trip and it gets hot (normal operating temp)the pressure drops down to the bottom mark on the gauge ,IS this normal or anything to worrie about ? Thanks for any help you fellas can give
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Rebuilt 2H motor,need advice
Moderators: toaddog, Elmo, DUDELUX
Re: Rebuilt 2H motor,need advice
Slowing down up hills - get used to it i'd say. Really depends what kionda hills your talking about.mudpog wrote:Just after some advice/info on this motor in my 75ser 85mod
ive recently rebuit mine everything was done and it seems 2 be a reel dog going up hills even the faintest hill seems to slow me down IS this normal ??? also im finding that when cold oil pressure is high wich is fine but when on a decent trip and it gets hot (normal operating temp)the pressure drops down to the bottom mark on the gauge ,IS this normal or anything to worrie about ? Thanks for any help you fellas can give
on the open road i can't accelerate up hills...
as for oil pressure, mine (rebuilt 2H) never drops down that low if it's got a few revs on board.
Tetanus rolling on 37's
what bigbrowndog said, factory sensors are vague new, and are known to fail and show bad readings later in life.
Did you replace the oil pump gears? if not you could genuinely have low pressure, which was disguised pre-rebuild by the buiuld up of sludge and carbon throughout your engine. I was advised that even if you had perfect oil pressure pre rebuild, you should always replace the oil pump, who wants to do it afterwards!?!?
Also did you rebuild the fuel pump? did you fit new/reco injectors?
Your old pump may not be able to deliver enough pressure to run new injectors effectively which will drop your power incredibly and certainly would presenty itself as gutless up hills. Old pump was capable of running worn injectors as they are far less restrictive when worn.
You can check this by getting the fuel pressure at each injector tested. There are specs for this in the toyota service manual.
Did you replace the oil pump gears? if not you could genuinely have low pressure, which was disguised pre-rebuild by the buiuld up of sludge and carbon throughout your engine. I was advised that even if you had perfect oil pressure pre rebuild, you should always replace the oil pump, who wants to do it afterwards!?!?
Also did you rebuild the fuel pump? did you fit new/reco injectors?
Your old pump may not be able to deliver enough pressure to run new injectors effectively which will drop your power incredibly and certainly would presenty itself as gutless up hills. Old pump was capable of running worn injectors as they are far less restrictive when worn.
You can check this by getting the fuel pressure at each injector tested. There are specs for this in the toyota service manual.
Who is online
Users browsing this forum: No registered users and 2 guests