Yesterday a few mates came over and just were mucking around and one of my mates was looking through my engine bay and we spotted a big cyclinder on the right side of the engine bay. its always been there ive just been to lazy to fiqure what it is. i looked through my haynes manual and it reckons its an early from of a cat convertor?
-do i need it?
-if i take it off will i get more power ?
(when i had my extrqactors put on i had the hot air injection disalbled, does this mean i still need the cyclinder)
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
What is this (in engine bay)
Moderator: -Scott-
What is this (in engine bay)
Real men smoke clutches
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
id leave it. its designed to be there for a reason. remove it if you need to put something else there.
i think it fould make the engine run worse and probably chew more fuel. espescially with todays fuel prices
i think it fould make the engine run worse and probably chew more fuel. espescially with todays fuel prices
my GUBanzy wrote:Dial up internet.........you'd post something and come back 2 beers later to see if it loaded.
Who is online
Users browsing this forum: No registered users and 0 guests