Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Td42 won't rev

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Posts: 94
Joined: Fri Sep 16, 2005 5:11 pm
Location: S.E.Qld.

Post by Gruntahunta »

Is this little filter only a GQ thing guys or did it go through to the GU's. I have a 4.2TD GU ute. If you don't ask you don't know??

Cheers...............Pete! :oops:
Artificial Intelligence is no match for Natural Stupidity!
Posts: 17
Joined: Sat Mar 05, 2005 5:17 pm
Location: Gawler East SA

Post by sox121 »

The filter is used in my 99 GU 4.2 non turbo DX and it makes a big improvement after a clean. ;)
Posts: 236
Joined: Thu Apr 27, 2006 9:40 pm
Location: Gippsland, Vic

Post by currentlyoffline »

Gruntahunta wrote:Is this little filter only a GQ thing guys or did it go through to the GU's. I have a 4.2TD GU ute. Cheers...............Pete! :oops:
I have a mate with a 2000 ST TD42 and it definately DOES have the gauze filter as he has had it out and checked it. ;) ( Macca @ Mulga OffRoad ) :armsup:
Posts: 2832
Joined: Sat Oct 26, 2002 3:15 pm
Location: Ringwood East, VIC

Post by RoldIT »

My 2000 GU coil/cab has it also, I have experienced this problem and a clean makes a farken huuuuuge difference!
KRiS
Posts: 236
Joined: Thu Apr 27, 2006 9:40 pm
Location: Gippsland, Vic

Post by currentlyoffline »

Just another note regarding checking the filter, The banjo fitting will have washers both above it and below it on the bolt.
These are either a steel washer with a gasket membrane on one side to seal the fitting, or a copper washer.
It could be either type as you get both in a seal kit for the pump. I am using the copper ones as there is no membrane to wear out, and they seem to work OK
Posts: 89
Joined: Mon Jun 05, 2006 9:26 am
Location: Sutherland Shire NSW

Post by GQSWB42td »

gday im just new to this and just only to hear about this filter. is this filter under both bolts on the fuel pump or just one. where can you get one and how much whats the part number thanks
building
Posts: 18
Joined: Sun Nov 20, 2005 6:03 am
Location: Whangarei, NewZealand

Post by Roga »

Hi Guys Sorry I have been away a while since I started this thread.

No I am positive mine does not have a filter in the injector pump as I have carefully slid a piece of wire about 40 mm down inside the pump with no obstruction,I think someone has thrown it away at some stage.
The model of my Patrol is 1988 and it has done 320000km but the pump & injectors have been rebuilt about 80000km ago.
I am interested in the comment about the fan clutch as mine wont cut in and out as my old patrol used to.
I have turned up the diesel on the pump last weekend to see what dif it made
It has a lot more power but will not rev above approx 3000 now
so it must be a blockage of some sort. This is also the most economical Patrol I have seen as it is using approx 1/2 the diesel of the last one although the last one was automatic.
Posts: 2832
Joined: Sat Oct 26, 2002 3:15 pm
Location: Ringwood East, VIC

Post by RoldIT »

GQSWB42td wrote:gday im just new to this and just only to hear about this filter. is this filter under both bolts on the fuel pump or just one. where can you get one and how much whats the part number thanks
Ummmmm ... read the WHOLE thread, all the info you asked for is there.
KRiS
Posts: 2832
Joined: Sat Oct 26, 2002 3:15 pm
Location: Ringwood East, VIC

Post by RoldIT »

Roga wrote:Hi Guys Sorry I have been away a while since I started this thread.

No I am positive mine does not have a filter in the injector pump as I have carefully slid a piece of wire about 40 mm down inside the pump with no obstruction,I think someone has thrown it away at some stage.
The model of my Patrol is 1988 and it has done 320000km but the pump & injectors have been rebuilt about 80000km ago.
I am interested in the comment about the fan clutch as mine wont cut in and out as my old patrol used to.
I have turned up the diesel on the pump last weekend to see what dif it made
It has a lot more power but will not rev above approx 3000 now
so it must be a blockage of some sort. This is also the most economical Patrol I have seen as it is using approx 1/2 the diesel of the last one although the last one was automatic.
Sounds like injectors are probably due for a service again.
KRiS
Posts: 236
Joined: Thu Apr 27, 2006 9:40 pm
Location: Gippsland, Vic

Part Numbers

Post by currentlyoffline »

I have 2 part numbers for the same filter. The Nissan genuine part is actually a bosch part with a Nissan sticker over the Bosch Sticker.

Nissan Part Number is 14371-R8025A
Bosch Part Number is 14612501016N1

Getting the Bosch part is about 1/2 the price of the Nissan part.
Just go to an injector service centre :roll:
Posts: 87
Joined: Mon Feb 21, 2005 10:23 pm
Location: perth, W.A

Post by cuzza »

I checked my pump today on my 94, td42 and I am pretty sure I do not have the filter. Is it possible to just buy one and put it in? I asume there would not, just thought I would check.

cheers
cuzza
Posts: 236
Joined: Thu Apr 27, 2006 9:40 pm
Location: Gippsland, Vic

Post by currentlyoffline »

cuzza wrote:Is it possible to just buy one and put it in? cuzza
I don't see why not, but you will need the gauze filter, and the spring which holds it in.
Check out the photo I posted in page 1 of this thread and make sure you checked the right banjo fitting to make sure it is not there.
An injector/diesel service should be able to supply you with the spring, filter, and washers if those above and below your banjo fitting are a bit sus.
Might even get out of it for less than $25.....
Posts: 162
Joined: Wed Feb 25, 2004 3:40 pm
Location: Newcastle

Post by 4Speed »

Just wanted to add my 2cents, 99GU DX.

Found the little filter this morning, flushed it and spring as well as the bolt with metho. Little bit of MP air and I have a new truck. Dam wished I new about that sooner.

cheers
God made reverse for tailgaters!!
But the white light is me!!
Posts: 24
Joined: Fri Mar 12, 2004 7:05 pm

Post by Rambo »

Roga, Does your engine sound like it's making a lot of excess fan noise under the hood? Thats what mine sounded like, because the fan was spinning at the same rpm's as the engine. The vicious oil in the fan should heat up after a very short period allowing the fan to spin slower and engine to rev freely(there by not pushing a whole lot of unneccessary air!) Hope that's all it is!
Posts: 18
Joined: Sun Nov 20, 2005 6:03 am
Location: Whangarei, NewZealand

Post by Roga »

Yes that is exactly what it sounds like although the fan turns as you would expect for a viscous hub type
Posts: 18
Joined: Sun Nov 20, 2005 6:03 am
Location: Whangarei, NewZealand

Post by Roga »

I have removed the fanblade for a quick run down the road and it revs fine!!
so I will be replacing the viscous hub asap !!
Thanks Rambo for your help.
Posts: 303
Joined: Tue Mar 22, 2005 2:47 pm
Location: NZ

Post by DieselBoy »

KIWI wrote:I had this problem, and found that it had a faulty TPS. Unplugged it, and it works fine now. My problem was accompanied by black smoke too though.


Dave
Hey dave, could you post up a pic of the TPS for me??

I have an electrical fitting on my pump covered in green plastic, is that what yours looked like?
Hold on, i have a picture:

Image
Image

And also an extra circut on my fuel filter housing. BLOODY STRANGE!!!!!

Image
Posts: 70
Joined: Sun May 22, 2005 10:55 pm
Location: harrisdale WA - gold coast

Post by WALKS »

just a quick quetin guys but do i need to bleed the fuel system if i un do this bolt looking for the flter :?:
88vx 60's sahara twin factory locked on 37's
Posts: 660
Joined: Sat Jul 30, 2005 5:43 pm
Location: No fixed address....

Post by GU BUG »

WALKS wrote:just a quick quetin guys but do i need to bleed the fuel system if i un do this bolt looking for the flter :?:
Yep...

I pulled the filter out tonight & I can't believe how much better it's running :D. It's definitely pulling a lot harder than it used to. Whilst the filter didn't seem all that dirty from looking at it, it must have been restricting it beforehand as there's a noticable increase in performance that's for sure :D...
More poke = More smoke!!!
Posts: 70
Joined: Sun May 22, 2005 10:55 pm
Location: harrisdale WA - gold coast

Post by WALKS »

thanks gu bug
88vx 60's sahara twin factory locked on 37's
Posts: 447
Joined: Mon Dec 15, 2003 8:44 am
Location: Townsville

Post by BigMav »

ok bringing this thread back to see if anyone knows what the part number is for the spring that goes on top of the small gauze filter. The number that fnqcairns has posted for the filter is a valid one but could not find a picture of it on fast at the nissan dealership for the life of me. The dude there is actually quite helpful most of the time and was suprised to see it come up as valid as he had never sold one before. Because we couldn't find a good pic of it anywhere though we don't have the number for the spring. Anyone know what it is because i want to fit one of these little filters.
1989 Ford Maverick Turbo Diesel Tourer
4" spring lift 2" body lift
33" MT/R's
Posts: 3237
Joined: Sun Aug 21, 2005 7:24 pm
Location: victoria point qld

Post by dirtyGQ »

yeh pulled the bolt out and can't find either the spring nor the gauze filter ... but i wished i could find one because mine is a slug....
Posts: 23
Joined: Sat Aug 12, 2006 10:10 am

Post by djd2 »

Would the Gu's have these same filters on their pumps.
Posts: 502
Joined: Thu Dec 01, 2005 12:09 pm
Location: Cairns

Post by fnqcairns »

dj, yep.

cheers fnq
*JUST LUV IT* 96 GQ LWB TD4.2, Cav, Kings, Dobinsons, Motorguard, Enginesaver, 400 pro, Cooper ST's (rolls eyes), fleetguard oil filters, Delo 400 engine oil, Delo ESI gearbox oil and an RTC.
Posts: 104
Joined: Tue Mar 08, 2005 10:29 pm
Location: Bundaberg, QLD

Post by mrbonk »

I just found this thread and, having delusions of suddenly finding masses of hitherto unknown power, went to have a look on my TD42. Alas, the previous owner has removed the filter and spring :bad-words: I don't know why I'm surprised really.....I've found so many other 'questionable' mods on it since I've owned it. Not least of which were the leopard skin seat covers :roll:
******
MrBonk
www.mrbonk.com
Posts: 1006
Joined: Wed Jan 07, 2004 8:25 pm
Location: Strapped into the Evil!

Post by BIg StEvE »

mrbonk wrote:I just found this thread and, having delusions of suddenly finding masses of hitherto unknown power, went to have a look on my TD42. Alas, the previous owner has removed the filter and spring :bad-words: I don't know why I'm surprised really.....I've found so many other 'questionable' mods on it since I've owned it. Not least of which were the leopard skin seat covers :roll:
I plan to have a look soon too. Just hopeing i find the filter and this power u all talk of! ahaha
Posts: 193
Joined: Mon Oct 31, 2005 6:21 pm
Location: BEECHWORTH NTH EAST VIC.

Post by GUte »

Rick130 and C.O.L you guys are bloody champions.
Could not get over 2800 RPM.
Cleaned the said filter and the thing flies.
Thanks heaps.
Al.
Posts: 569
Joined: Sun Jan 11, 2004 11:36 am
Location: Sunshine Coast QLD

Post by Mark2 »

I know this a bit of a dig but,

After coming accross this thread I went out and bought a filter and spring since mine was missing.

Am I right in saying that the filter sits under the spring?

Which way does the filter go in - brass ring up or down?
Posts: 2832
Joined: Sat Oct 26, 2002 3:15 pm
Location: Ringwood East, VIC

Post by RoldIT »

Filter mesh pointing down with brass ring up, then spring dropped in on top of filter then banjo connection bolted back on.
KRiS
Posts: 2254
Joined: Tue Dec 10, 2002 5:09 pm
Location: Sydney

Post by jessie928 »

MORAL of the story is.

DONT use cheap arse diesel filters.

JEs
ATTACH BROKEN TOYOTA HERE--->
DUCATI <-----Worlds best warning label
Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests