Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

92 Mitsibishi Pajero 3L V6 Manual

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Post Reply
Posts: 104
Joined: Tue Feb 28, 2006 12:02 pm

92 Mitsibishi Pajero 3L V6 Manual

Post by millers1 »

Hi all my neighbour has a 92 mitsi GLS V6 3.0L manual, problem is it has developed a water leak today (coolant) and is runniung from the back of the motor and down onto the gear box bell housing, we think where it is leaking from is at the back of the motor there is a heater hose that connects to a metal pipe which from what we can see (virtually impossible) runs back into the block we are assuming as we cant see it properly, does or has any body had this problem before, if so what was the requirement to get it fixed. By the look of it to me it will require the gear box to be removed and fixed that way,as you can only just get your fingers down in behind the motor, We can see the welsh plugs on the back of the heads and there is definately no leaks there so its coming from that pipe as mentioned above,any help would be appreciated. Regards Steve M
Posts: 167
Joined: Wed Jul 21, 2004 10:23 pm
Location: Tassie

Post by GREGGO »

It could also be from a leaking waterpump. If you do a quick search you should find a few other links that will discribe similar symptoms.

Greggo
Shorty Gen2, lots of stuff and more to come!
Posts: 180
Joined: Wed Aug 18, 2004 7:57 pm
Location: packahoonaham

Post by corkhead »

when i did my first motor swap ... it leaked from there back of motor there is a pipe that runs from the back of the block to the intake plenum/carby on drivers side of motor (heats the carby i think) lucky for me it was only we didnt tighten that hose clamp - but have seen them rust there before ! if you dont have a body lift - is a bitch to get to !
www.victoriancampertrailers.com.au
www.salon13.com.au
Posts: 2739
Joined: Sat Oct 26, 2002 7:50 am
Location: Melbourne

Post by Bitsamissin »

Yep my guess is water pump (mine was doing a similar thing).
Coolant leaked from the rear water pump seal and ran along the block and dripped on the ground at the rear of the motor.
The other suspect is the hose you described which is a bitch of a job to replace.
I just luv my "clacker Jabber"
Posts: 71
Joined: Sat Jan 01, 2005 10:37 pm
Location: Melbourne Australia

Post by rhymus »

I had a similar leak that went from minor to major. I thought it was an o-ring on the pipe that runs from front to back under the intake manifold. I was so convinced that this was the case that I started to pull it down to fix it only to find it was one of the small heater hoses that are at the back of the engine. It is a bit of a pain to get in there but it can be done without too much trouble. If you are going to do it change all of them at once. No sense doing it twice!! Check your hoses back there. Hope this helps.
92 NH Pajero, MQ Patrol 50mm lift. One has custom rust, dents & rattles, the other has a blown engine.
Post Reply

Who is online

Users browsing this forum: No registered users and 17 guests