My fuel guage on my SWB Mav does not work properly, when i fill it up it the needle gets to 3/4 and stops and then drops to 1/4 after driving for about 50k's. It will then drop to empty but still have plenty of fuel left. What are my options? would it be something simple?
Also the drivers side electric windows are buggered, it will allow me to open the passenger window but not the drivers (no good when your trying to order macca's drive through). Would i need a new motor? cheap?
cheers
Duncan...
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Fuel Guage and electric window problems on SWB Mav.
Fuel Guage and electric window problems on SWB Mav.
www.outbackproven.com.au
For all your TUFF outback camping & 4wdriving gear!!!!
For all your TUFF outback camping & 4wdriving gear!!!!
ok fuel gauge problem could be a bad earth. GQ electric windows are notorious for problems. my drivers door had the same problem. this is what fixed mine.
i pulled off the door trim. there is a small box with a circuit board and a relay in it. slide this out of the box and spray the relay with WD40 or similar. this fixed mine. it appears that the relay gets stuck. my back windows are buggered too but thats a problem with the cog in the mechanisms.
i pulled off the door trim. there is a small box with a circuit board and a relay in it. slide this out of the box and spray the relay with WD40 or similar. this fixed mine. it appears that the relay gets stuck. my back windows are buggered too but thats a problem with the cog in the mechanisms.
hi-luxmadness if you want a cheap fix for the cog slipping problem on the rear windows try this.
Take the motor assembly off the door take off circlip holding cog on to motor then pull the cog out and put it back in backwards, if your slipping problem was the same as mine it was not the cog section that was stripped. Mine was stripped where the 4 cams hold the cog in place.
From memory I had to ditch one of the packing washers but just make sure that its all nice and tight and the cogs should not slip again.
Take the motor assembly off the door take off circlip holding cog on to motor then pull the cog out and put it back in backwards, if your slipping problem was the same as mine it was not the cog section that was stripped. Mine was stripped where the 4 cams hold the cog in place.
From memory I had to ditch one of the packing washers but just make sure that its all nice and tight and the cogs should not slip again.
94 GQ TD42 Turbo Intercooler 4 1/2" lift with all the fruit.
thanks for that, ill have a look and try thatSmithyGQ wrote:hi-luxmadness if you want a cheap fix for the cog slipping problem on the rear windows try this.
Take the motor assembly off the door take off circlip holding cog on to motor then pull the cog out and put it back in backwards, if your slipping problem was the same as mine it was not the cog section that was stripped. Mine was stripped where the 4 cams hold the cog in place.
From memory I had to ditch one of the packing washers but just make sure that its all nice and tight and the cogs should not slip again.
Who is online
Users browsing this forum: No registered users and 10 guests