I've done a lot of reading and have a couple of questions on the following setup that would be going in a Jeep running 37's. Basic setup that I'm considering is:
* Axle sides 'flipped' to make the diff a passenger side drop
* Some trussing
* MQ knuckles for high-steer
The rear can just be transplanted after replacing all the bracketry because the standard Jeep diff is only about 1.5" off being centred.
I'm looking for info on:
* Who in the ACT or Melbourne area it's worth talking to to get the work done
* There was some talk recently about twin piston GQ front brakes - can these be used on the MQ knuckles
* Does anyone have a ballopark feel for what the work is likely to cost (assuming that I'd already sourced the diffs)
Thanks.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Considering GQs for a diff swap project
Considering GQs for a diff swap project
I'm not very good looking, so I guess I better be useful . . .
Who is online
Users browsing this forum: No registered users and 63 guests