Anyone know what the Timming set up is for a 3.9efi V8?
Got it all back in and running just need to know what to set the timming at.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
3.9 rover Timming settings?
Moderator: Micka
For Disco motor
2 degrees low comp initial setting. Should run ok at this.
6 degrees on aussie ULP
6 to 10 on lpg
Will supposedly make more torque at 2 after tdc but economy suffers.
Ensure you do a TDC check as many markings are known to be out.
ie No 1 at tdc measured at piston thru plug hole to timing mark tdc.
Airflow may be too lean. Adj with allen key on side for about 2% co.
Out is lean, in (clockwise) is richer.
bazzle
2 degrees low comp initial setting. Should run ok at this.
6 degrees on aussie ULP
6 to 10 on lpg
Will supposedly make more torque at 2 after tdc but economy suffers.
Ensure you do a TDC check as many markings are known to be out.
ie No 1 at tdc measured at piston thru plug hole to timing mark tdc.
Airflow may be too lean. Adj with allen key on side for about 2% co.
Out is lean, in (clockwise) is richer.
bazzle
Who is online
Users browsing this forum: No registered users and 1 guest