Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

3.5 v6 rear axle, does any one have any measurments.

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Forum rules
Post Reply
Posts: 397
Joined: Fri Jan 03, 2003 6:21 am
Location: USA

3.5 v6 rear axle, does any one have any measurments.

Post by DougH »

Some one is looking to use one of these axles as an alternative to the gm 14 bolt, or the dana 60.

Personally I dont need the 3.5 sized axle, so I think I will let him in on our little secret. I am sure in a couple years there will be more than enough of these axles in junkyards and cheap too.

I was hoping to find out the folowing information:

Number of splines
Axle shaft size
Ring gear size

Width.

Any any other goodies you might now.

Thanks
DougH
95SR: locked front and rear, more coming soon.
Top
Posts: 2739
Joined: Sat Oct 26, 2002 7:50 am
Location: Melbourne

Post by Bitsamissin »

Yes I've measured one :-
- 10" diameter crownwheel
- 31 spline
- 35.5mm axle shaft diameter (at the spline)
Not sure of length though but probly slightly shorter than a 3.0 V6 axle because of the larger diff centre.
I just luv my "clacker Jabber"
Top
Post Reply

Return to “Mitsubishi”

Who is online

Users browsing this forum: No registered users and 0 guests