Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

3F Extractors

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 17
Joined: Wed Jun 06, 2007 6:20 pm
Location: Sydney

3F Extractors

Post by Bobbles »

Hi
Are the 2F extractors a match to the 3F? I have a 3F engine in a troopy and want to get some extractors however you see more advertised for the 2F then for the 3F. Is it possible to bolt the 2F extractors onto the 3F engine?
Thanks for any help
Rob
Posts: 1590
Joined: Fri Jun 03, 2005 7:07 pm
Location: Tarneit, Vic

Post by matt.mcinnes »

The issue is the 3F is a shorter block by quite a bit. I would say the extrators would sit too low to where you want to connect to the exhaust if you used ones for a 2F
http://www.fj40-2f-eti-locked-n-loaded.com

Advanced (HB) Intercoolers
http://advancedhbintercoolers.com
Posts: 1109
Joined: Mon Feb 12, 2007 8:48 pm
Location: Australia

Post by hulsty »

I bought a 2F gasket and 3F gasket and the bolt patterns are different, might pay to check that out more
Posts: 46
Joined: Mon Jun 04, 2007 11:25 am
Location: Alexandra Hills

Post by mac85 »

I have had extractors on both a 2F and 3F and they are different. As indicated above, they look similar, but the bolt pattern is slightly different and the base of the extractors will probably sit well below the chassis line. I have never had a problem getting extractors for my 3F, and as my 60 is 25 years old I am on my third set. It is important to get a quality set, otherwise they can rust out in a short time (as I found out)! Dirt can build up in the area where the header pipes come together and this can lead to rust problems when the engine is cool.
1985 FJ62 2" lift
2001 HJZ105 3" lift & locked
Posts: 17
Joined: Wed Jun 06, 2007 6:20 pm
Location: Sydney

Post by Bobbles »

Cheers thanks guys
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests