Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Lighting butane filled tyre to explode the bead back on rim
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Lighting butane filled tyre to explode the bead back on rim
It actualy worked!!!!!
I rolled the 38.5inch swamper front tyre off the rim in a deep bog hole, drove under a tree and used a hand winch to get the front off the ground becasue a jack would have sunk in the soft mud.
Punchered the end in on a portable BBQ butane can and filled the floppy tyre with the gas. Dipped a stick in petrol and held the tyre in place as best as I cound then my mate lit her up. It went bang and the tyre was perfectly seated on the rim!
In seconds it then started to vacume in with the air inside burning and we got the compressor on it just in time before it sucked the bead back off.
next time I would taek the valve out to avoid this
I burnt my hand a bit but with a crowd gathering for the show it was very very cool that it worked!
I rolled the 38.5inch swamper front tyre off the rim in a deep bog hole, drove under a tree and used a hand winch to get the front off the ground becasue a jack would have sunk in the soft mud.
Punchered the end in on a portable BBQ butane can and filled the floppy tyre with the gas. Dipped a stick in petrol and held the tyre in place as best as I cound then my mate lit her up. It went bang and the tyre was perfectly seated on the rim!
In seconds it then started to vacume in with the air inside burning and we got the compressor on it just in time before it sucked the bead back off.
next time I would taek the valve out to avoid this
I burnt my hand a bit but with a crowd gathering for the show it was very very cool that it worked!
Last edited by BIG ZOOK on Mon Jun 29, 2009 2:38 pm, edited 1 time in total.
Owner of 2 FJ40's, 1 for hard offroading with no roof and 1 for on road cruising with a roof.. perfect!
thanks! yes was really exciting. I think I had the no fear frame of mind becasue I had had half a bottle of Jager so that helps!
Last edited by BIG ZOOK on Mon Jun 29, 2009 3:59 pm, edited 2 times in total.
Owner of 2 FJ40's, 1 for hard offroading with no roof and 1 for on road cruising with a roof.. perfect!
And it sucked the 38 in like a flat pan cake!mur wrote:The "vacuum in" wouldn’t have been air burning, all the oxygen in the tyre would have been used up with the initial explosion.
The decrease in pressure would have been the gas inside cooling down and shrinking.
Well done on getting out of a bad situation.
Owner of 2 FJ40's, 1 for hard offroading with no roof and 1 for on road cruising with a roof.. perfect!
You weren't drinking and driving were you?BIG ZOOK wrote:thanks! yes was really exciting. I think I had the no fear frame of mind becasue I had had half a bottle of Jager so that helps!
Light and run...
[img][img]http://i421.photobucket.com/albums/pp30 ... oyota1.jpg[/img][/img]
The butane will only seat youre bead mate, its not quite magical enough to actually fit youre tyre onto the rim lolJeeps wrote:You weren't drinking and driving were you?BIG ZOOK wrote:thanks! yes was really exciting. I think I had the no fear frame of mind becasue I had had half a bottle of Jager so that helps!
Light and run...
[img][img]http://i421.photobucket.com/albums/pp30 ... oyota1.jpg[/img][/img]
If you can get an air hose to the valve straight after the bead seating then you can leave the valve in.GU-ish wrote:well i learn something new everyday.
is it better to do it with the valve in or out?
If there is a delay in getting air into tyre the vacuum may suck the bead/s back off again so it may pay to remove the valve.
i dunno... i havn't got a blue 40 series... apparently those 40 series blokes can do anything...PJ.zook wrote:The butane will only seat youre bead mate, its not quite magical enough to actually fit youre tyre onto the rim lolJeeps wrote:You weren't drinking and driving were you?BIG ZOOK wrote:thanks! yes was really exciting. I think I had the no fear frame of mind becasue I had had half a bottle of Jager so that helps!
Light and run...
[img][img]http://i421.photobucket.com/albums/pp30 ... oyota1.jpg[/img][/img]
you definitely know boats AtholBIG ZOOK wrote:thanks! yes was really exciting. I think I had the no fear frame of mind becasue I had had half a bottle of Jager so that helps!
Outers & Arms up stickers coming soon you hungry bitches!
http://www.myultimate4wd.com
http://www.myultimate4wd.com
GRIMACE wrote:How I miss the days of care free wheelin with the crews!
Great picJeeps wrote:You weren't drinking and driving were you?BIG ZOOK wrote:thanks! yes was really exciting. I think I had the no fear frame of mind becasue I had had half a bottle of Jager so that helps!
Light and run...
[img][img]http://i421.photobucket.com/albums/pp30 ... oyota1.jpg[/img][/img]
Owner of 2 FJ40's, 1 for hard offroading with no roof and 1 for on road cruising with a roof.. perfect!
Road Ranger
and will release poisonous air when next deflatedRoldIT wrote:Fixed.BIG ZOOK wrote:these tyres are for sale if anyone wants. 38.5x14.5x15 Swamper SX (ones with the meaty side tread) plenty of tread, full of mud and slight internal melting. make an offer
Owner of 2 FJ40's, 1 for hard offroading with no roof and 1 for on road cruising with a roof.. perfect!
Who is online
Users browsing this forum: No registered users and 127 guests