Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
torsion bar- sway bar
Moderators: toaddog, TWISTY, V8Patrol, Moderators
torsion bar- sway bar
Im thinking of using a torsion bar from a ford courier as a sway bar for the back of a CJ6 jeep to stiffen it up on the road. How do I Guestimate how long the lever arms should be?
Its a wheelbase thing
Hmm very tough one to figure out.. to figure it out properly you would need to know the torsion rate of the bar and the rough force in which you want to dampen the body roll at the point in which the bar is connected to the chassis.. i would prob go with about the same length arms that torque the bar on the courier suspension.. I would imagine they would be about right.. could make it with a bit of adjustment built in too perhaps? are you going to make it with a quick disconnect?
Craig
Craig
14 - 16 inches , for a 300 pound , the shorter the arm the stiffer. A 300 pound bar should work ok on a cj6 , I am putting the same on a cj5 , patrol diffs , 350 chev , turbo 350 , 36 inch swampers. With the long arm it will more than likely flex with the bar connected , and it will provide great stability on and off road , Cheers Paul.
BLOWNZUK 1.3 efi,sc14 supercharger,hilux diffs,detroit lockers,stage 4 rockhopper,6 point cage,35 muddies.
Who is online
Users browsing this forum: No registered users and 137 guests