Hey guys just wondering is there a change in engine mounts and bell housing from the 2L 2.4 Toyota Hulix and the 3L 2.8 Hulix.
I have a 1990 Hilux with no motor and can get a 2L turbo
Thx guys
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
2L into a 3L
Moderators: toaddog, Elmo, DUDELUX
You should be good to go (same block), may need a different gearbox cross member depending on which box you use. Manual Surf's run a "R" series box.
If your using a Surf turbo setup, watch out for the brake lines at the master as a non-turbo version has them exit the master on the engine side (close to turbo).
If the 3L is in decent condition, might want to bolt the turbo gear on the 3L
If your using a Surf turbo setup, watch out for the brake lines at the master as a non-turbo version has them exit the master on the engine side (close to turbo).
If the 3L is in decent condition, might want to bolt the turbo gear on the 3L
91' Hilux Surf with the usual mods & a few different ones ....
Coil SAS by www.budscustoms.com.au
Coil SAS by www.budscustoms.com.au
Who is online
Users browsing this forum: No registered users and 0 guests