brake load sensing valve mods ?

Post by **cookie monster** » Wed Feb 23, 2005 10:42 pm

hi all,
just had a look at the nissan pages and found a question relating to the adjustment of the rear brake proportioning valve after a lift.

did think about that when i put the nissan springs in the back.
has anybody got any info on what neds to be done to adjust them to work correctly ?
will have a look this weekend and see if i can come up with anything, but if someone already has some experience with them, that would be great.

cookie

Post by **-Scott-** » Thu Feb 24, 2005 11:22 am

Good point - didn't do a thing to mine during body/suspension lift. :oops:

But I haven't had a problem, either... Perhaps I'll get real good life from my rear pads? :armsup:

Cheers,

Scott

Post by **Bitsamissin** » Fri Feb 25, 2005 8:19 am

http://www.outerlimits4x4.com/PHP_Modul ... hp?t=37751

I just bent the bracket on mine originally when the 2.5" springs went in.

Post by **cookie monster** » Fri Feb 25, 2005 5:59 pm

Bitsamissin wrote:http://www.outerlimits4x4.com/PHP_Modules/phpBB2/viewtopic.php?t=37751

I just bent the bracket on mine originally when the 2.5" springs went in.

had a look in the workshop manual and that stated a 'free lenght' of 224 to 228mm.
mine is approx 200 now.
will move the bkt as far back on the slots as it goes, then get the rest by the very technical 'bending' proceedure !

cookie

Outer Limits 4x4 Board

brake load sensing valve mods ?

brake load sensing valve mods ?

Who is online