Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

2H oil pressure slow to rise when cold

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 285
Joined: Sun Aug 15, 2004 9:31 am
Location: Sydney

2H oil pressure slow to rise when cold

Post by dibbz »

When I start the 2H the oil pressure takes a while to get up, unelss you rev it up around 1200-1500 the engine will stop, takes 2 or 3 starts from cold before the pressure rises and the engine stays running.

Is this a common thing with 2H's?

Churs.
Posts: 66
Joined: Thu Apr 15, 2004 11:30 am
Location: Northern Territory

oil

Post by griff »

check sender - notorious for dicky readings
Griff
TD42 GQ Wagon
FJ75 Troopy
Posts: 17
Joined: Thu Mar 31, 2005 7:56 pm
Location: Limbri

Post by auntygranty »

mate the old girls 2h is probly a bit tierd
same deal with mine along with low compression after 490000kms
if your rocker gear and bearings arnt flogged out you might want to check out the relef valves theres two I beleve
one around the oil filter housing the other you need to take the sump off best way to find out is to put a master gauge on and check the oil preasure
OR

keep a few revs up when you start her :!:
Posts: 48
Joined: Thu Jun 17, 2004 4:49 pm
Location: Mount Isa

Post by paul1a »

My 2H takes ages to get up the oil pressure up & I reckon if I had the engine management system hooked up it would shut the engine down. However I had a look at the mains & big end bearings a while back & plastigauged them & they were near perfect so I just don't worry about it anymore :cool:
Posts: 810
Joined: Thu Jul 15, 2004 8:02 am
Location: Somewhere in NSW

Post by brighty »

what would be a good PSI reading for the 2H when cold... and when warm/running temp???
When in doubt..... UTE-ERIZE it!!!
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests