Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
T-cases
Moderator: Micka
LT230 came out in 5 speed RR. All 4 speeds are a one piece gearbox/transfer. they continued on in the disco's in both auto's and manuals
Some of the RR auto's (depending which one) had LT230 but not all of them did.
Low range is 3.32 no matter what it is out of, only the high range is different
you can get maxi drive low range gears (only change low range), they have 4.1's and I belive just brought out a lower (4.5 ?) version again. both require case grinding.
Ashcroft gears (http://www.ashcroft-transmissions.co.uk/part_48.html) have just released a full gearset (replaces all gears in the TC) with a low range of 5.95 and I believe there is no grinding of casing.
Some of the RR auto's (depending which one) had LT230 but not all of them did.
Low range is 3.32 no matter what it is out of, only the high range is different
you can get maxi drive low range gears (only change low range), they have 4.1's and I belive just brought out a lower (4.5 ?) version again. both require case grinding.
Ashcroft gears (http://www.ashcroft-transmissions.co.uk/part_48.html) have just released a full gearset (replaces all gears in the TC) with a low range of 5.95 and I believe there is no grinding of casing.
[i]DAS[/i]
MY05 4.4L V8 Range Rover Vogue
Series 2a Buggy....In the Building
MY05 4.4L V8 Range Rover Vogue
Series 2a Buggy....In the Building
Maxi drives new gear set is a 4.9 not 4.5. I have a set of these in my buggy. Dont be put off by the case grinding its easy to do with a 4" angle grinder.GURU wrote:LT230 came out in 5 speed RR. All 4 speeds are a one piece gearbox/transfer. they continued on in the disco's in both auto's and manuals
Some of the RR auto's (depending which one) had LT230 but not all of them did.
Low range is 3.32 no matter what it is out of, only the high range is different
you can get maxi drive low range gears (only change low range), they have 4.1's and I belive just brought out a lower (4.5 ?) version again. both require case grinding.
Ashcroft gears (http://www.ashcroft-transmissions.co.uk/part_48.html) have just released a full gearset (replaces all gears in the TC) with a low range of 5.95 and I believe there is no grinding of casing.
yeah i wasn't sure..hence the ? on the new maxi set.RUFF wrote:
Maxi drives new gear set is a 4.9 not 4.5. I have a set of these in my buggy. Dont be put off by the case grinding its easy to do with a 4" angle grinder.
the grinding isn't a problem but it does take strength out of the case if too much has to be taken off (don't think maxi's are a probelm though)
[i]DAS[/i]
MY05 4.4L V8 Range Rover Vogue
Series 2a Buggy....In the Building
MY05 4.4L V8 Range Rover Vogue
Series 2a Buggy....In the Building
No difference fitting gears to a lux t-case So what is one of these LT230RUFF wrote:Maxi drives new gear set is a 4.9 not 4.5. I have a set of these in my buggy. Dont be put off by the case grinding its easy to do with a 4" angle grinder.GURU wrote:LT230 came out in 5 speed RR. All 4 speeds are a one piece gearbox/transfer. they continued on in the disco's in both auto's and manuals
Some of the RR auto's (depending which one) had LT230 but not all of them did.
Low range is 3.32 no matter what it is out of, only the high range is different
you can get maxi drive low range gears (only change low range), they have 4.1's and I belive just brought out a lower (4.5 ?) version again. both require case grinding.
Ashcroft gears (http://www.ashcroft-transmissions.co.uk/part_48.html) have just released a full gearset (replaces all gears in the TC) with a low range of 5.95 and I believe there is no grinding of casing.
worth and what are the gears worth.
You can get a whole Rangie for under a grand if you look hard enough. Just make sure it has a torque flyte in it. Also look at 5 speed Countys.dave wrote:No difference fitting gears to a lux t-case So what is one of these LT230RUFF wrote:Maxi drives new gear set is a 4.9 not 4.5. I have a set of these in my buggy. Dont be put off by the case grinding its easy to do with a 4" angle grinder.GURU wrote:LT230 came out in 5 speed RR. All 4 speeds are a one piece gearbox/transfer. they continued on in the disco's in both auto's and manuals
Some of the RR auto's (depending which one) had LT230 but not all of them did.
Low range is 3.32 no matter what it is out of, only the high range is different
you can get maxi drive low range gears (only change low range), they have 4.1's and I belive just brought out a lower (4.5 ?) version again. both require case grinding.
Ashcroft gears (http://www.ashcroft-transmissions.co.uk/part_48.html) have just released a full gearset (replaces all gears in the TC) with a low range of 5.95 and I believe there is no grinding of casing.
worth and what are the gears worth.
[quote="Wooders"]If ya want a 4x4 camry go ahead & buy a Patrol or Cruiser.[/quote]Rangie with 80s LC diffs, Isuzu 4bd1, Twin ARB lockers, 8000lb Hi mount warn, 315x75x16 Procomp XTerrains
I have seen a few of them go for about $300 in the past. The Maxi Drive 4.1 gearset was $1700 last time I asked, so I imagine the 4.9 set is the same or more.dave wrote:So what is one of these LT230
worth and what are the gears worth.
_____________________________________________________________
RUFF wrote:Beally STFU Your becoming a real PITA.
Maxi drive low gears can't be fitted to early LT230's.
The LT230 must have taper roller bearing intermediate shaft - early models have needle roller bearings.
The correct models are easy to tell from the outside because they have a nut on the rear of the intermediate shaft to adjust the bearing pre-load.
The LT230 must have taper roller bearing intermediate shaft - early models have needle roller bearings.
The correct models are easy to tell from the outside because they have a nut on the rear of the intermediate shaft to adjust the bearing pre-load.
John
Had a quote from Dave Ashcroft. If we can get 5 sets together, 500 pounds each plus freight.GURU wrote:The Ashcroft gears are 650 pounds and 96 pounds to to get them here to your door.
So thats around $1900 I'm estimating..
Worth trying to get a bulk buy.
[quote="Wooders"]If ya want a 4x4 camry go ahead & buy a Patrol or Cruiser.[/quote]Rangie with 80s LC diffs, Isuzu 4bd1, Twin ARB lockers, 8000lb Hi mount warn, 315x75x16 Procomp XTerrains
If so let me know as I am trying to cut cost on the Crawler Unit (bolts to PTO output) as the gears dont interest me.Maggot4x4 wrote:Had a quote from Dave Ashcroft. If we can get 5 sets together, 500 pounds each plus freight.GURU wrote:The Ashcroft gears are 650 pounds and 96 pounds to to get them here to your door.
So thats around $1900 I'm estimating..
Worth trying to get a bulk buy.
So far its just looking way to exxy to bring one in on my own if i can save abit in both purchase price and shared freight I would be a much happier chappy
Don't forget the Customs man..GURU wrote:The Ashcroft gears are 650 pounds and 96 pounds to to get them here to your door.
So thats around $1900 I'm estimating..
Maybe double that for duty, then add 10% to the whole lot..
I haven't looked for a while, maybe the 30% duty for cars 30 years & older still applies, I dunno.
How many pre 1975 LRs had an LT230??
Regards
Max P
Stereo by Simex!
OK;
Under Drive------£1,500.00
Frieght------------£295.00-TNT-economy-express
Gears-------------£150.00
Sub Total---------£1,945.00
Convert to-$-----0.4155 Current rate
Cost in dollars---$4,681.11
Duty--------------5%
Duty Amount----$198.56
Sub Total $------- $4,879.66
GST 10%----------$488.00
Customs clearence--$50.00
Total:-------------$5417.66 aprox.
Freight= Basic charge 0-30 KG $90.00----30-60KG $ 110.00 plus $9.10 per kg. economy air.
Have fun,
Michael.
Under Drive------£1,500.00
Frieght------------£295.00-TNT-economy-express
Gears-------------£150.00
Sub Total---------£1,945.00
Convert to-$-----0.4155 Current rate
Cost in dollars---$4,681.11
Duty--------------5%
Duty Amount----$198.56
Sub Total $------- $4,879.66
GST 10%----------$488.00
Customs clearence--$50.00
Total:-------------$5417.66 aprox.
Freight= Basic charge 0-30 KG $90.00----30-60KG $ 110.00 plus $9.10 per kg. economy air.
Have fun,
Michael.
Mitsubishi 2010 NT DID Pajero wagon, Factory rear diff lock, Dual batteries, ARB bar, winch, Mt ATZ 4 rib tyres.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
I know and its still around $5000 with out the new gearset for the LT230HSV Rangie wrote:OK;
Under Drive------£1,500.00
Frieght------------£295.00-TNT-economy-express
Gears-------------£150.00
Sub Total---------£1,945.00
Convert to-$-----0.4155 Current rate
Cost in dollars---$4,681.11
Duty--------------5%
Duty Amount----$198.56
Sub Total $------- $4,879.66
GST 10%----------$488.00
Customs clearence--$50.00
Total:-------------$5417.66 aprox.
Freight= Basic charge 0-30 KG $90.00----30-60KG $ 110.00 plus $9.10 per kg. economy air.
Have fun,
Michael.
Who is online
Users browsing this forum: No registered users and 0 guests