Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

engine mount help

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 199
Joined: Wed Jun 29, 2005 12:55 pm
Location: Gold Coast

engine mount help

Post by Rascal »

I have a 84 4runner which I need to move the engine mounts forward to suit a deisel, problem is not sure excactly how far forward. If someone could measure from the top of the crossmember to the bottom edge of the engine mount as shown in the pic it would be much appreciated.
Image

Cheers RB
Top
Posts: 346
Joined: Fri Dec 06, 2002 6:08 am
Location: New Zealand

Post by Julian_4x4 »

i have an 84 hilux shouldnt be much different. My measurement are 559 millimetres
hope this helps mate ;)
Top
Posts: 199
Joined: Wed Jun 29, 2005 12:55 pm
Location: Gold Coast

Post by Rascal »

Thanks for that Julian.
Top
Posts: 3
Joined: Tue Jun 21, 2005 8:31 pm
Location: lilydale

Post by mudtruckin »

I've just done a swap from a 3Y to a later petrol engine and found out that you need to get the engine mounts out of the same chassis as the motor that you're fitting. If you're fitting a 2.8 get the mounts out of a LN106. If you've got a solid axle make sure you get corresponding mounts, as IFS is different.
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 3 guests