could some one give me a few pointers on where not to use the disconnect rear swaybar handle,
a mate has said not on angles as the vehicle will tend to roll,,
any other opinions please,
thanks inadvance
Scruffy
89 lwb gq
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
swaybar disconnect question
What lift you running?
With a 4" and over, you can totally stuff a swaybar as you will have more flex than the bar can handle.
I have lost mine altogether. I don't miss them either. Good shocks have a lot to do with good road manners and bodyroll.
Offroad bodyroll on sideslopes is not an issue for me either.
With a 4" and over, you can totally stuff a swaybar as you will have more flex than the bar can handle.
I have lost mine altogether. I don't miss them either. Good shocks have a lot to do with good road manners and bodyroll.
Offroad bodyroll on sideslopes is not an issue for me either.
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...
On my family wagon I've put the rear swaybar back on - rig handles better all around. The swaybar isn't real big to influence the handling off road anyway. We run a 6" coil, I've lengthened the links to correct (neutralise) the bar's location. I feel the swaybar evens out the handling offroad - helps to place more (marginally) pressure onthe front end to perform - the rears are quite flexy. I wouldn't stress too much where or when you disconnect the bar.
do you mean the factory disconnect? if so all it does is allow one end of the sway bar to move up and down about 40 mm or so.
Even 2" lifted springs can put too much stress on the little balljoints on either side of the swaybar if you dont disconnect it when in terrain that causes one rear wheel to to flex a fair bit.
Use the disconnect when driving over undulating terrain [to take the pressure off the little ball joints].
And use the disconnect whet travelling over potholed or rough ground as it allows one wheel to drop into holes without pulling the whole body down and makes it a much more comfortable ride.
The disconnect makes buggerall difference to side slopes unless your right on the point of rolling over.
shane
Even 2" lifted springs can put too much stress on the little balljoints on either side of the swaybar if you dont disconnect it when in terrain that causes one rear wheel to to flex a fair bit.
Use the disconnect when driving over undulating terrain [to take the pressure off the little ball joints].
And use the disconnect whet travelling over potholed or rough ground as it allows one wheel to drop into holes without pulling the whole body down and makes it a much more comfortable ride.
The disconnect makes buggerall difference to side slopes unless your right on the point of rolling over.
shane
[url=http://bigred.redbubble.com/][color=red][b]You can follow me but its gunna hurt ![/b][/color][/url]
event pics http://bigred.redbubble.com/
event pics http://bigred.redbubble.com/
Who is online
Users browsing this forum: No registered users and 0 guests