if i pull out a sals centre, when putting it back in do i have to set it up, or is it just a bolt in and forget job? (assuming it was right originally)
thanks
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
quick sals question.
Moderator: Micka
quick sals question.
Ex-Army - SeriesIII -186s - NP435 - Maxi rear - megasquirt coilpack ignition - AM FM radio with 2 X speakers
If it is doing back into the same housing with the same bearings and bearing shims then it is fine.
Although the manual says you need a spreader, you actually only need gentle pressure from a couple of tyre levers to remove, and a leather/rubber hammer to refit.
Although the manual says you need a spreader, you actually only need gentle pressure from a couple of tyre levers to remove, and a leather/rubber hammer to refit.
_____________________________________________________________
RUFF wrote:Beally STFU Your becoming a real PITA.
Who is online
Users browsing this forum: No registered users and 0 guests