Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

GQ Fuel Consumption

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 63
Joined: Tue May 31, 2005 9:58 pm
Location: Carlingford, NSW

GQ Fuel Consumption

Post by challenger »

We all complain about it! The TB42 petrol engine is very heavy on fuel.

Our learned colleague "Bogged" will say it's all been tried before and is a waste of time, but contrary to what he thinks there is no reason why good maintenance and performance tuning techniques cannot improve both the performance AND economy of these motors.

I have a 1990 Maverick with 4.2 carby petrol motor. Over the next 6-12 months I will be carefully measuring my petrol consumption BEFORE and AFTER some simple motor work. I will be upgrading the following:

1. The exhaust: fitting a set of 2.5 inch or 3 inch extractors and hi-flow mufflers;
2. The ignition: adding a CDI ignition system, high-energy coil, performance leads and modified rotor button. I will be staying with points however for bush reliability. Why? The CDI system removes the need for high current to flow through the points. The result is that the points should last 50K+ before needing to be changed. And if the CDI fails, I can still get home;
3. Adding a snorkel and opening up the air intake: to increase the volume of cooler air entering the carby;
4. A free-flow performance air filter;
5. Dyno tuning: to get the timing and carby absolutely correct;
6. High performance oil, such as Penrite 15W50;
7. Experiment with the spark plug range: normal, hotter, cooler

At each stage I will carefully check the consumption, and use my best judgement as to whether I have gained economy and/or power.

I would be very interested if anyone has attempted something similar. If so, please share your results.

Cheers

Dave
Last edited by challenger on Mon Jan 09, 2006 7:24 am, edited 1 time in total.
Dave Golding
0413 743 872
dgolding01@optusnet.com.au
Posts: 2097
Joined: Mon Jun 14, 2004 8:06 pm
Location: Land of Plenty

Post by blkmav »

You can throw a lot of $$ at a TB42 for little improvement. The best thing I did to reducce my fuel comsumption was to lighten my right foot. :lol:
Weekdays - Prado GXL D4D with some stuff
Weekends - Mav shorty with lots of stuff
Posts: 63
Joined: Tue May 31, 2005 9:58 pm
Location: Carlingford, NSW

Post by challenger »

Agreed, but I intend to try. Everything can be improved, with not too much $$ spend.
blkmav wrote:You can throw a lot of $$ at a TB42 for little improvement. The best thing I did to reducce my fuel comsumption was to lighten my right foot. :lol:
Dave Golding
0413 743 872
dgolding01@optusnet.com.au
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Re: GQ Fuel Consumption

Post by bogged »

challenger wrote:We all complain about it! The TB42 petrol engine is very heavy on fuel.

But there is no reason why good maintenance and performance tuning techniques cannot dramatically improve both the performance AND economy of these motors.

I have a 1990 Maverick with 4.2 carby petrol motor. Over the next 6-12 months I will be carefully measuring my petrol consumption BEFORE and AFTER some simple motor work. I will be upgrading the following:

1. The exhaust: fitting a set of 2.5 inch or 3 inch extractors and hi-flow mufflers;
2. The ignition: adding a CDI ignition system, high-energy coil, performance leads and modified rotor button. I will be staying with points however for bush reliability. Why? The CDI system removes the need for high current to flow through the points. The result is that the points should last 50K+ before needing to be changed. And if the CDI fails, I can still get home;
3. Adding a snorkel and opening up the air intake: to increase the volume of cooler air entering the carby;
4. A free-flow performance air filter;
5. Dyno tuning: to get the timing and carby absolutely correct;
6. High performance oil, such as Penrite 15W50;
7. Experiment with the spark plug range: normal, hotter, cooler

At each stage I will carefully check the consumption, and use my best judgement as to whether I have gained economy and/or power.

I would be very interested if anyone has attempted something similar. If so, please share your results.

Cheers

Dave
people on patrol list have tried all this over the years, with little or not worthy improvement for the investment.
Posts: 63
Joined: Tue May 31, 2005 9:58 pm
Location: Carlingford, NSW

Post by challenger »

OK, so what worked and what didn't?
----------------------------------------------------------
"...people on patrol list have tried all this over the years, with little or not worthy improvement for the investment."
Last edited by challenger on Mon Jan 09, 2006 7:25 am, edited 1 time in total.
Dave Golding
0413 743 872
dgolding01@optusnet.com.au
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

challenger wrote:Rather than being totally negative, what worked and what didn't.

Please qualify your comments for each suggestion.
----------------------------------------------------------
"...people on patrol list have tried all this over the years, with little or not worthy improvement for the investment."
go search the archives.. CBF.
Posts: 63
Joined: Tue May 31, 2005 9:58 pm
Location: Carlingford, NSW

Post by challenger »

As some members seem to think they own this forum, if anyone else is interested or keen to offer constructive help and/or suggestions, please send me a PM, and we will keep what we learn to ourselves.
Dave Golding
0413 743 872
dgolding01@optusnet.com.au
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

challenger wrote:As some members seem to think they own this forum, if anyone else is interested or keen to offer constructive help and/or suggestions, please send me a PM, and we will keep what we learn to ourselves.
would you like a tissue?
Posts: 63
Joined: Tue May 31, 2005 9:58 pm
Location: Carlingford, NSW

Post by challenger »

Yes please.
Dave Golding
0413 743 872
dgolding01@optusnet.com.au
Posts: 63
Joined: Tue May 31, 2005 9:58 pm
Location: Carlingford, NSW

Post by challenger »

Yes please, but would accept a new set of tyres instead.
Dave Golding
0413 743 872
dgolding01@optusnet.com.au
Posts: 5521
Joined: Tue Jan 13, 2004 12:09 pm

Post by mkpatrol »

bogged wrote:
challenger wrote:As some members seem to think they own this forum, if anyone else is interested or keen to offer constructive help and/or suggestions, please send me a PM, and we will keep what we learn to ourselves.
would you like a tissue?

You can be such a tool sometimes Bogged :roll:
Don't ask me, ask them. I'm just runnin for my life myself.
Well they are all following you...
No they ain't, I'm just in front...............
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

mkpatrol wrote:You can be such a tool sometimes Bogged :roll:
:armsup: :armsup:
Posts: 5521
Joined: Tue Jan 13, 2004 12:09 pm

Post by mkpatrol »

It wasnt a compliment :D
Don't ask me, ask them. I'm just runnin for my life myself.
Well they are all following you...
No they ain't, I'm just in front...............
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

mkpatrol wrote:It wasnt a compliment :D
i know
Posts: 5521
Joined: Tue Jan 13, 2004 12:09 pm

Post by mkpatrol »

U made him go quiet :D
Don't ask me, ask them. I'm just runnin for my life myself.
Well they are all following you...
No they ain't, I'm just in front...............
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests