Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Ive read in the tech articles and in my pajero manual that the maximum angle the pajero can be driven on is 35 degrees. Why only 35. What happens after 35 degrees.
The only real time ive driven for and extended period of time over 35 degrees was up a step fire trail and the g/box freaked out and fel out of 1st low and engagded reverse as well
Real men smoke clutches
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
I think they needed a figure, so they picked 35 degrees. Beyond that, I guess it could struggle for traction on climb/descent, and there's the roll-over prospect on a side slope.
after comming down a long 35 ish slope i was followed by a bit cloud of smoke, ok it was more of a small cloud. but i point is that the oil moves and doesn't reach where it's needed at those angles. one of the more techy guys and fill in the huge gaps i have left.
NCpaj wrote:
The only real time ive driven for and extended period of time over 35 degrees was up a step fire trail and the g/box freaked out and fel out of 1st low and engagded reverse as well
Hava you actually measured that slope. Or was it seat of the pants feeling. 35 degrees is hell of lot steep. If it was a 2nd then usually its about = 2 * actuall slope. One would be really hard pressed to find slope over 35-40 degrees this side of the rock face. Generally loose material cannot creat slope over 40 degrees it will just colapse.
the pajeros have a built in inclonomiter and i have seen one hit 40 degrees (it was in zoot's lwb he was to busy reversing down a hell of a steep fire trail to be watching it.
yeah i got one of those incilometers and from memory it said round 35' . And yes i was sh*ting myself cause i had to make it to the top or reverse down.
Real men smoke clutches
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
I do these kind of angles on a weekly basis for my job.
You are correct in the assumption that loose material (angle of repose) is around 35 degrees for sand and 37 degree loose rock (Mine surveyor talking here) And you are again right in saying angles feel twice as bad as they really are
I get to drive down these angles in a sand mine all day long!!!!
You have BIG problems getting up the dunes anything above 17 degrees.
Zute wrote:Um, while I would like to bragg of being able to drive up 40deg slop and reverse down again. It was more like 30deg. sorry Matt.
the slope might have been 30 degrees most of the time but comming of the last hump (the first one you reversed off) it was on 40 degrees, if only for a second. but your right i'll shut up now
One other factor is suspension. Climbing steep hill front suspesion relaxes while rear is compressed which can lead to perception of steeper angle than it actually is. I'd say 5 degrees or more is not out of the question. Same happens down hill and traverse.