Outer Limits 4x4 Board

2 years ago was in stranded in coober pedy for a few days waithing on seals for leaking fuel injectors. Got doug at Bulls mechanical to fit them . Really happy with the service.

Hi there, I have a 93Gq 4.2 EFI running on dual fuel. Had been having a problem with it not running on petrol due to severe backfireing.Running fine on gas. Tracked it down to the airflow metre which I replaced with a new genuine one. Truck has been running great for 3months but now since the other ...

mine is 6inch spring 3inch body and drives fine. Sure a little top heavy but drive accordingly.Do a fair amount of touring and am also about to go around oz. If everything is done properly there is no worries. I say go for it.

got mine from 4wd1.

hi guys . on installing lockers have picked one of my rear axles is twisted. Just after some advice on if the only option is to go genuine nissan or if there is after market ones available.If so what is recomended. also only one axle is twisted . Should i put two new ones in while it is all apart ...

was looking at getting a cheaper set myself but after comparing them all at the 4wd show i relised that nothing comes close to the quality of the black widow. yes they are more expensive but can take them to the next car. lifetime warranty too.

yeah thought binskins do them

leave it in and just smash the centre out of it so it looks like its there

have found the 6"extra heavy duty dobinsons to sit up higher than everyone elses 7"

just got my 4.6's from big balls. they were $399 on special

hi all ,i drive a 93 gq 4.2petrol and was just wondering what ratios would be in this and what i need to change to to get gearing back to standard with 35's. Also are the cheaper gears from big balls ok or do i go genuine?
thanks

Just wondering if anyone knows anything about the marks adaptors ratio boxs? Is that a good way to recalibrate?

Hey guys, would like some advice on fitting in my aux. 73L long range automotive petrol tank into my lwb gq. The truck has a 7-8 inch suspension lift so the tank is fouling on the upper control arm a fair bit. Looks like i need to cut a fair bit out of tank to make it fit. probably about 150mm just ...

hi there, ive got 7inch spring ,3inch body running 35s which have been all cut up on the inside at the rear from rubbing on the chassis and body so what i need 2 know is there some offset rims i can buy?? . If so how much offset do i need?? Still running standard flares which would like to keep ...

gday ,
just wondering what is the highest amp hr battery i can get to go in the small 8in gq efi dual battery tray. The biggest ive seen is 65a/h was hoping to get a 100a/h in there. Does anyone know approx. how long the 65a/h will run a 40L engal.
Thanks